Blown output transformer

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Blown output transformer

Radioroslyn
Phorum Expert

Posts: 7,285
Threads: 268
Joined: Dec 2009
City: Roslyn Pa

10-26-2023, 09:38 PM

Seems the this transformer has a pretty high impedance primary at 50K. The load for each of the 1A5's is 25k. The highest thing that I could find is 25K to 4 ohm vc. https://www.tubesandmore.com/products/tr...-push-pull 125A or https://www.ebay.com/itm/186125514312?ha...R_zGr-ntYg

GL

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry

(This post was last modified: 10-26-2023, 10:18 PM by Radioroslyn.)

Find

« Next Oldest | Next Newest »

Messages In This Thread

Blown output transformer - by Tynwald - 10-26-2023, 04:08 PM

RE: Blown output transformer - by Radioroslyn - 10-26-2023, 09:38 PM

RE: Blown output transformer - by Radioroslyn - 10-27-2023, 06:30 AM

RE: Blown output transformer - by radiorich - 10-27-2023, 08:02 AM

RE: Blown output transformer - by Tynwald - 10-27-2023, 11:35 AM

RE: Blown output transformer - by Radioroslyn - 10-27-2023, 12:29 PM

RE: Blown output transformer - by Tynwald - 10-27-2023, 04:12 PM

View a Printable Version

Users browsing this thread: 2 Guest(s)

Recent Posts
trying to identify this wire type
Thanks to all for the feedback. As Arran said, it is probably an older replacement and yes it has a grid cap so I will ...georgetownjohn — 09:32 PM
trying to identify this wire type
It's possible that the red wire, actually a grid cap lead, is a very old replacement, I can't remember seeing a pre 1939...Arran — 09:18 PM
Gilfillan Brothers Car Radio?
Hi everyone, Special thanks to Joe Rossi for tracking down this obscure radio and thanks to others who took up the hun...Antipodal — 08:15 PM
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached. I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM

Who's Online

There are currently 5180 online users. [Complete List]
» 1 Member(s) | 5179 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me