Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

40-165 vs 41-260
#2

Hi Jayce
The sets are pretty similar but the '165 has a rf amp before the mixer, but the '260 has no rf amp but two IF amps
So the '165 should pickup more stations (has more front end gain) but can't separate them apart where the '260 should be able to separate them better (better selectivity because of more IF gain).
Audio looks to be the same. I'd say it's a toss up.
Terry

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry


Messages In This Thread
40-165 vs 41-260 - by Jayce - 07-02-2011, 08:57 PM
Re: 40-165 vs 41-260 - by 7estatdef - 07-02-2011, 09:34 PM
Re: 40-165 vs 41-260 - by Jayce - 07-03-2011, 02:49 PM



Users browsing this thread:
[-]
Recent Posts
1949 Motorola 5A9M
Haven't thought of Burgess batteres in a while  https://www.radionostalgia.ca/lib/Images/battery/us/burgess1D.jpgi ...Vlad95 — 03:50 PM
Philco Model 16 wiring question
Measure the voltages first, just in case.morzh — 02:19 PM
1949 Motorola 5A9M
Haven't thought of Burgess batteries in a while Mr. Fixer. Boston Edison always used Burgess in their Bright Star yellow...Paul Philco322 — 02:17 PM
1949 Motorola 5A9M
Thanks Sam. I'll let you know. I can probably scare some up from the local radio club.klondike98 — 02:07 PM
Philco 89 Code 123 Osc Coil
Hello,  I thought I would post my findings on my bad oscillator tickler coil. There were 27 turns on the outer coil b...dconant — 12:38 PM
Philco Model 16 wiring question
Thanks Morzh. So it appears I did wire it incorrectly and I have to switch the wires between pins 2 and 4.bobclausen — 09:24 AM
Philco 46-1209 strange behavior
No, it's not a problem, just during certain condition it could show up. Yes, an internal tube short could do that too. ...morzh — 09:13 AM
HiFi (Chifi) tube amp build - but my own design.
You sound guys are never satisfied. :crazy: :clap:RodB — 09:10 AM
HiFi (Chifi) tube amp build - but my own design.
I got some new ceramic octal tube sockets installed and also tried some different coupling caps.  The results:  The go...TV MAN — 08:42 AM
Philco 46-1209 strange behavior
I pulled the tube out and it's shorted from pin 1 to pin 2. I suppose that's the problem...sq65 — 08:12 AM

[-]
Who's Online
There are currently 1145 online users. [Complete List]
» 1 Member(s) | 1144 Guest(s)
Avatar

>