Chassis bolts for '30s sets

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Chassis bolts for '30s sets

Radioroslyn
Phorum Expert

Posts: 7,285
Threads: 268
Joined: Dec 2009
City: Roslyn Pa

12-17-2023, 08:13 PM

I was looking for something over in the McMaster Carr catalog and found these instead https://www.mcmaster.com/products/hex-he...eet-metal/ pn 93880A544. Look like they would be a good replacement for missing chassis to cabinet bolts for the pre '37 or so sets. I'm always either loosing them or getting sets that have missing ones or none at all. Haven't ordered yet as I just found them.

Actually I was looking for some hardware bits to put a 21, 70B, and a 90B back together. Some came a chassis w/o cabinets others needed a few things to tiddy it up or just have been around so long I've lost track of some of the bits...

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry

Find

« Next Oldest | Next Newest »

Messages In This Thread

Chassis bolts for '30s sets - by Radioroslyn - 12-17-2023, 08:13 PM

RE: Chassis bolts for '30s sets - by radiorich - 12-18-2023, 01:22 AM

RE: Chassis bolts for '30s sets - by Radioroslyn - 12-21-2023, 11:43 AM

RE: Chassis bolts for '30s sets - by DaleHCook - 12-21-2023, 12:03 PM

RE: Chassis bolts for '30s sets - by Radioroslyn - 12-22-2023, 06:41 PM

RE: Chassis bolts for '30s sets - by Radioroslyn - 12-28-2023, 11:12 AM

RE: Chassis bolts for '30s sets - by RodB - 12-28-2023, 11:58 AM

RE: Chassis bolts for '30s sets - by Steve Davis - 12-28-2023, 11:59 AM

RE: Chassis bolts for '30s sets - by Steve Davis - 12-28-2023, 04:27 PM

RE: Chassis bolts for '30s sets - by Radioroslyn - 12-28-2023, 04:32 PM

RE: Chassis bolts for '30s sets - by Radioroslyn - 12-29-2023, 10:06 PM

RE: Chassis bolts for '30s sets - by Bruce - 08-10-2024, 02:57 PM

View a Printable Version

Users browsing this thread: 4 Guest(s)

Recent Posts
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached. I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM

Who's Online

There are currently 6295 online users. [Complete List]
» 1 Member(s) | 6294 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me