Philco 37-61

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Philco 37-61

RodB
Phorum Expert

Posts: 990
Threads: 40
Joined: Feb 2015
City: Roseville, MN

#27

12-26-2023, 08:48 PM

It appears to me that block 46 has been relocated to the low position in the photo and the mystery block is in the upper spot. The power line is connected to the lower block.

The 20K and 51K voltage divider is connected to the upper block. Looking at the schematic, that point has part 16 (0.1 mfd) supplying screen voltage to two tubes. Part 16 is probably in the unknown block. I checked earlier for a service bulletin but couldn't find one. It looks like this configuration has been there awhile, can't explain why it's this way. You'll have to check the wiring to verify that point runs to the screen grids and the wiring for the other lug.

Find

« Next Oldest | Next Newest »

Messages In This Thread

Philco 37-61 - by 7chip7 - 12-11-2023, 09:04 PM

RE: Philco 37-61 - by Radioroslyn - 12-11-2023, 10:44 PM

RE: Philco 37-61 - by 7chip7 - 12-11-2023, 11:23 PM

RE: Philco 37-61 - by GarySP - 12-11-2023, 11:31 PM

RE: Philco 37-61 - by Radioroslyn - 12-12-2023, 01:11 AM

RE: Philco 37-61 - by 7chip7 - 12-12-2023, 11:18 AM

RE: Philco 37-61 - by klondike98 - 12-12-2023, 01:48 PM

RE: Philco 37-61 - by 7chip7 - 12-12-2023, 03:38 PM

RE: Philco 37-61 - by klondike98 - 12-13-2023, 02:01 PM

RE: Philco 37-61 - by MrFixr55 - 12-14-2023, 09:12 AM

RE: Philco 37-61 - by 7chip7 - 12-16-2023, 12:22 PM

RE: Philco 37-61 - by radiorich - 12-16-2023, 01:50 PM

RE: Philco 37-61 - by klondike98 - 12-16-2023, 05:44 PM

RE: Philco 37-61 - by 7chip7 - 12-18-2023, 11:27 AM

RE: Philco 37-61 - by 7chip7 - 12-18-2023, 11:47 AM

RE: Philco 37-61 - by David - 12-18-2023, 01:37 PM

RE: Philco 37-61 - by 7chip7 - 12-24-2023, 09:44 AM

RE: Philco 37-61 - by RodB - 12-24-2023, 10:33 AM

RE: Philco 37-61 - by Radioroslyn - 12-24-2023, 10:38 AM

RE: Philco 37-61 - by 7chip7 - 12-25-2023, 11:17 AM

RE: Philco 37-61 - by Radioroslyn - 12-25-2023, 03:03 PM

RE: Philco 37-61 - by RodB - 12-25-2023, 04:51 PM

RE: Philco 37-61 - by 7chip7 - 12-26-2023, 07:25 AM

RE: Philco 37-61 - by Radioroslyn - 12-26-2023, 10:17 AM

RE: Philco 37-61 - by 7chip7 - 12-26-2023, 11:29 AM

RE: Philco 37-61 - by Radioroslyn - 12-26-2023, 05:09 PM

RE: Philco 37-61 - by RodB - 12-26-2023, 08:48 PM

RE: Philco 37-61 - by 7chip7 - 12-27-2023, 08:08 AM

RE: Philco 37-61 - by 7chip7 - 12-30-2023, 08:22 AM

RE: Philco 37-61 - by Radioroslyn - 12-30-2023, 09:01 AM

RE: Philco 37-61 - by 7chip7 - 12-30-2023, 09:45 AM

RE: Philco 37-61 - by RodB - 12-30-2023, 09:49 AM

RE: Philco 37-61 - by 7chip7 - 12-30-2023, 02:03 PM

RE: Philco 37-61 - by 7chip7 - 12-30-2023, 04:30 PM

RE: Philco 37-61 - by RodB - 12-30-2023, 05:53 PM

RE: Philco 37-61 - by 7chip7 - 12-31-2023, 02:18 PM

RE: Philco 37-61 - by RodB - 01-01-2024, 12:03 PM

RE: Philco 37-61 - by Radioroslyn - 01-01-2024, 01:44 PM

RE: Philco 37-61 - by 7chip7 - 01-01-2024, 03:40 PM

37-61 Speaker Repair - by 7chip7 - 01-03-2024, 09:01 AM

View a Printable Version

Users browsing this thread: 3 Guest(s)

Recent Posts
Philco 16B Parts
Thanks for the reply. Unfortunately the radio was removed before bidding was over so I didn't get a chance to bid.dconant — 04:10 PM
Philco 16B Parts
Hi Dan, Mike is correct, there's a lot of painted stuff on the chassis but it looks pretty good. The sm is all there,sp...Radioroslyn — 03:50 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Hi Cap'n Clock, Unfortunately, I do not have this radio. This is a shame because this should be a good performer. 2A...captainclock1988 — 03:43 PM
Philco 42-390, code 121 speaker
Using a 5W 1.5k ceramic resistor in place of the field coil and using a 4 ohm PM speaker, I was able to bring the radi...Stevelog — 02:57 PM
Philco 60 Squealing
I have taken out the 2nd IF and found a problem or not. I believe the coils are litz wire. There is a very small strand ...dconant — 02:13 PM
Philco 6K7
I am restoring a Philco 37-60. The am reception is very good, but the shortwave is very weak. Run 6 Philco removes the g...bobbyd1200 — 01:35 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Hi Cap'n Clock, Unfortunately, I do not have this radio. This is a shame because this should be a good performer. 2A5...MrFixr55 — 06:48 AM
American Bosch Model 802 auto radio
I think it would come under either American Bosch or United American Bosch. American Bosch made sets for the American We...Arran — 05:53 AM
trying to identify this wire type
Thanks to all for the feedback. As Arran said, it is probably an older replacement and yes it has a grid cap so I will ...georgetownjohn — 09:32 PM
trying to identify this wire type
It's possible that the red wire, actually a grid cap lead, is a very old replacement, I can't remember seeing a pre 1939...Arran — 09:18 PM

Who's Online

There are currently 4797 online users. [Complete List]
» 1 Member(s) | 4796 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me