Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 60 code 121 IF's
#9

Yes I can hear one station weak with the radio but very strong with the signal tracer. I also used a test radio and could hear the whistle when oscillated. I believe the osc coil is okay, I took it out of the radio and it looks good as well. I can get the 460 signal thru the radio right up to the output coil/speaker. I can't send the 460 signal from the antenna clip thru the radio, but I can send 1400, 600 faintly? If you look at the schematic, on the antenna coil you will see a .7 ohm coil on the bottom, lug #4, I don't see that on this radio or measure it from #4. This could be the problem. Hopefully, tomorrow I will put the osc coil back in and remove the antenna coil and examine it. The antenna coil ohms out good.

Thanks for your reply

Oh, on the osc coil measurements I didn't subtract the resistance (ohms) of my meter leads. Better yet.

Jim
Spring Lake MI


Messages In This Thread
Philco 60 code 121 IF's - by Jimradio - 03-14-2024, 07:43 PM
RE: Philco 60 code 121 IF's - by MrFixr55 - 03-15-2024, 10:16 AM
RE: Philco 60 code 121 IF's - by Jimradio - 03-15-2024, 02:19 PM
RE: Philco 60 code 121 IF's - by Jimradio - 03-19-2024, 07:43 AM
RE: Philco 60 code 121 IF's - by RodB - 03-19-2024, 10:19 AM
RE: Philco 60 code 121 IF's - by Jimradio - 03-19-2024, 01:56 PM
RE: Philco 60 code 121 IF's - by Jimradio - 03-19-2024, 03:32 PM
RE: Philco 60 code 121 IF's - by Radioroslyn - 03-19-2024, 05:29 PM
RE: Philco 60 code 121 IF's - by Jimradio - 03-19-2024, 07:27 PM
RE: Philco 60 code 121 IF's - by Radioroslyn - 03-20-2024, 06:27 AM
RE: Philco 60 code 121 IF's - by Jimradio - 03-20-2024, 09:58 AM
RE: Philco 60 code 121 IF's - by radiorich - 03-21-2024, 09:09 AM
RE: Philco 60 code 121 IF's - by Jimradio - 03-21-2024, 11:46 AM
RE: Philco 60 code 121 IF's - by klondike98 - 03-21-2024, 12:04 PM
RE: Philco 60 code 121 IF's - by Radioroslyn - 03-21-2024, 08:51 PM
RE: Philco 60 code 121 IF's - by Jimradio - 03-22-2024, 07:57 AM
RE: Philco 60 code 121 IF's - by radiorich - 03-22-2024, 08:17 AM
RE: Philco 60 code 121 IF's - by Jimradio - 03-22-2024, 11:19 AM
RE: Philco 60 code 121 IF's - by Radioroslyn - 03-22-2024, 12:55 PM
RE: Philco 60 code 121 IF's - by Jimradio - 03-29-2024, 07:48 AM
RE: Philco 60 code 121 IF's - by RodB - 03-29-2024, 10:36 AM
RE: Philco 60 code 121 IF's - by Jimradio - 03-29-2024, 03:09 PM
RE: Philco 60 code 121 IF's - by Jimradio - 03-30-2024, 03:54 PM
RE: Philco 60 code 121 IF's - by Jimradio - 04-04-2024, 09:47 AM



Users browsing this thread: 4 Guest(s)
[-]
Recent Posts
Shadow Meter Bulb
Phorum members, I am trying to find the bulb # for PHILCO Shadow Meter part number 45-2180 that is from a 37-640 chassis...georgetownjohn — 06:53 PM
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM

[-]
Who's Online
There are currently 5804 online users. [Complete List]
» 2 Member(s) | 5802 Guest(s)
AvatarAvatar

>