48-461

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

48-461

RodB
Phorum Expert

Posts: 990
Threads: 40
Joined: Feb 2015
City: Roseville, MN

05-04-2024, 01:48 PM

The reason I asked for a photo was to discover if the antenna is part of the cabinet or mounted on the chassis and how it attaches. You can use any nondestructive method, Including the tacks. I see that the antenna lead wires are soldered so the antenna is meant to be a permanent attachment to the cabinet. If you don't want the tacks you can use a few dabs of hot glue or equivalent, just in case the antenna has to be removed.

You are correct about the safety cap; should be an "X" rated. Just be sure it gets installed after the power switch as in the schematic.

Find

« Next Oldest | Next Newest »

Messages In This Thread

48-461 - by philco4me - 05-03-2024, 04:46 PM

RE: 48-461 - by RodB - 05-03-2024, 10:37 PM

RE: 48-461 - by philco4me - 05-03-2024, 11:07 PM

RE: 48-461 - by philco4me - 05-04-2024, 08:29 AM

RE: 48-461 - by RodB - 05-04-2024, 09:52 AM

RE: 48-461 - by philco4me - 05-04-2024, 10:13 AM

RE: 48-461 - by RodB - 05-04-2024, 01:48 PM

RE: 48-461 - by philco4me - 05-04-2024, 02:13 PM

RE: 48-461 - by morzh - 05-04-2024, 04:53 PM

RE: 48-461 - by philco4me - 05-04-2024, 10:58 PM

RE: 48-461 - by klondike98 - 05-05-2024, 03:32 PM

RE: 48-461 - by philco4me - 05-05-2024, 05:41 PM

RE: 48-461 - by philco4me - 05-07-2024, 08:37 PM

RE: 48-461 - by RodB - 05-08-2024, 09:30 AM

RE: 48-461 - by philco4me - 05-08-2024, 09:47 AM

RE: 48-461 - by klondike98 - 05-08-2024, 08:21 PM

RE: 48-461 - by philco4me - 05-08-2024, 08:33 PM

RE: 48-461 - by philco4me - 05-10-2024, 01:06 PM

RE: 48-461 - by David - 05-10-2024, 03:49 PM

RE: 48-461 - by RodB - 05-10-2024, 03:58 PM

RE: 48-461 - by philco4me - 05-10-2024, 04:05 PM

View a Printable Version

Users browsing this thread: 2 Guest(s)

Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

Who's Online

There are currently 6098 online users. [Complete List]
» 2 Member(s) | 6096 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me