1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
48-461
David
Phorum Expert
*****
Posts: 1,191
Threads: 25
Joined: Jan 2014
City: Wellborn Florida
#19

05-10-2024, 03:49 PM
The narrow blade is the hot wire and the wide blade is the neutral. Connect the hot side to the on/off switch be careful working on a AC-DC set they can bite. Best to have a isolation transformer hooked up when working on the set. Take Care David
Find
« Next Oldest | Next Newest »


Messages In This Thread
48-461 - by philco4me - 05-03-2024, 04:46 PM
RE: 48-461 - by RodB - 05-03-2024, 10:37 PM
RE: 48-461 - by philco4me - 05-03-2024, 11:07 PM
RE: 48-461 - by philco4me - 05-04-2024, 08:29 AM
RE: 48-461 - by RodB - 05-04-2024, 09:52 AM
RE: 48-461 - by philco4me - 05-04-2024, 10:13 AM
RE: 48-461 - by RodB - 05-04-2024, 01:48 PM
RE: 48-461 - by philco4me - 05-04-2024, 02:13 PM
RE: 48-461 - by morzh - 05-04-2024, 04:53 PM
RE: 48-461 - by philco4me - 05-04-2024, 10:58 PM
RE: 48-461 - by klondike98 - 05-05-2024, 03:32 PM
RE: 48-461 - by philco4me - 05-05-2024, 05:41 PM
RE: 48-461 - by philco4me - 05-07-2024, 08:37 PM
RE: 48-461 - by RodB - 05-08-2024, 09:30 AM
RE: 48-461 - by philco4me - 05-08-2024, 09:47 AM
RE: 48-461 - by klondike98 - 05-08-2024, 08:21 PM
RE: 48-461 - by philco4me - 05-08-2024, 08:33 PM
RE: 48-461 - by philco4me - 05-10-2024, 01:06 PM
RE: 48-461 - by David - 05-10-2024, 03:49 PM
RE: 48-461 - by RodB - 05-10-2024, 03:58 PM
RE: 48-461 - by philco4me - 05-10-2024, 04:05 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

[-]
Who's Online
There are currently 6983 online users. [Complete List]
» 1 Member(s) | 6982 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration