46-1203 No sound

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

46-1203 No sound

dporcaro
Junior Member

Posts: 7
Threads: 1
Joined: Jun 2024
City: Mount Pleasant State, Province, Country: Wisconsin

06-21-2024, 10:46 AM

Got it. Thanks Ron. Am I correct in thinking that the test equipment (scope or signal generator) and the equipment under test should be plugged into the isolation transformer?

I will get one.

Dino

Find

« Next Oldest | Next Newest »

Messages In This Thread

46-1203 No sound - by dporcaro - 06-21-2024, 01:14 AM

RE: 46-1203 No sound - by 462ron - 06-21-2024, 08:14 AM

RE: 46-1203 No sound - by dporcaro - 06-21-2024, 10:46 AM

RE: 46-1203 No sound - by morzh - 06-21-2024, 10:50 AM

RE: 46-1203 No sound - by Chas - 06-21-2024, 11:02 AM

RE: 46-1203 No sound - by dporcaro - 06-21-2024, 08:17 PM

RE: 46-1203 No sound - by morzh - 06-21-2024, 08:36 PM

RE: 46-1203 No sound - by Chas - 06-21-2024, 09:29 PM

RE: 46-1203 No sound - by 462ron - 06-22-2024, 08:09 AM

RE: 46-1203 No sound - by mancave - 06-27-2024, 06:53 AM

RE: 46-1203 No sound - by dporcaro - 07-06-2024, 12:29 AM

RE: 46-1203 No sound - by morzh - 07-06-2024, 01:45 PM

RE: 46-1203 No sound - by dporcaro - 07-07-2024, 11:15 PM

RE: 46-1203 No sound - by Chas - 07-08-2024, 08:56 AM

RE: 46-1203 No sound - by RodB - 07-08-2024, 10:28 AM

RE: 46-1203 No sound - by dporcaro - 07-10-2024, 09:31 AM

RE: 46-1203 No sound - by MrFixr55 - 07-10-2024, 05:57 PM

RE: 46-1203 No sound - by dporcaro - 07-12-2024, 01:51 PM

View a Printable Version

Users browsing this thread: 3 Guest(s)

Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

Who's Online

There are currently 7073 online users. [Complete List]
» 2 Member(s) | 7071 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me