1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco 37-620 vs. 38-620 Speakers
Hilliard528
Junior Member
**
Posts: 6
Threads: 2
Joined: Jul 2024
City: Pawleys Island State, Province, Country: South Carolina
#1

07-08-2024, 01:11 PM
Hi all - Recently joined as I am restoring a Philco 37-620 Console and looking to find a working speaker.  I have my eyes on a 38-620 Speaker, unsure if they are interchangeable.  My 37-620, has 3 wires to the radio.  I already mistakenly bought one with 4 wires and it does not fit.  Any guidance on 37-620 and 38-620 speaker interchangeability is appreciated.  Thanks - Steve
Find
« Next Oldest | Next Newest »


Messages In This Thread
Philco 37-620 vs. 38-620 Speakers - by Hilliard528 - 07-08-2024, 01:11 PM
RE: Philco 37-620 vs. 38-620 Speakers - by GarySP - 07-08-2024, 01:36 PM
RE: Philco 37-620 vs. 38-620 Speakers - by RodB - 07-08-2024, 04:58 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

[-]
Who's Online
There are currently 6805 online users. [Complete List]
» 1 Member(s) | 6804 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration