Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

SABA 400 Automatic Stereo 11
#11

I have three German radios of my own, including the Emud T7 that transformer burnt out on a few years after it was totally rebuilt. Ron actually commented on that one while he was still with us telling us how he had a restored radio chassis do that right on the repair bench while doing the final test run. I also have the little German radio my late radio buddy worked on that made him swear to never ever repair another German radio again! I agree about the average AM performance of most German radios, though the ones I have usually do well on FM and shortwave overall. I am usually amazed how well they do with the lower tube counts, but they did tend to stick with all nine pin tubes that usually handled multiple tasks. One of the tubes in the SABA 400 for example is a triple diode-triode.

No matter where you go, there you are.


Messages In This Thread
SABA 400 Automatic Stereo 11 - by Jayce - 07-08-2024, 02:52 PM
RE: SABA 400 Automatic Stereo 11 - by RodB - 07-08-2024, 04:50 PM
RE: SABA 400 Automatic Stereo 11 - by Jayce - 07-08-2024, 05:19 PM
RE: SABA 400 Automatic Stereo 11 - by RodB - 07-09-2024, 08:36 AM
RE: SABA 400 Automatic Stereo 11 - by morzh - 07-09-2024, 02:26 PM
RE: SABA 400 Automatic Stereo 11 - by Jayce - 07-09-2024, 05:04 PM
RE: SABA 400 Automatic Stereo 11 - by morzh - 07-09-2024, 05:24 PM
RE: SABA 400 Automatic Stereo 11 - by Arran - 07-09-2024, 11:56 PM
RE: SABA 400 Automatic Stereo 11 - by GarySP - 07-10-2024, 07:19 AM
RE: SABA 400 Automatic Stereo 11 - by Jayce - 07-10-2024, 08:43 AM
RE: SABA 400 Automatic Stereo 11 - by morzh - 07-10-2024, 03:03 PM
RE: SABA 400 Automatic Stereo 11 - by RodB - 07-10-2024, 03:13 PM
RE: SABA 400 Automatic Stereo 11 - by Arran - 07-10-2024, 04:15 PM
RE: SABA 400 Automatic Stereo 11 - by morzh - 07-10-2024, 09:46 PM
RE: SABA 400 Automatic Stereo 11 - by Jayce - 07-11-2024, 01:37 PM
RE: SABA 400 Automatic Stereo 11 - by RadioSvit - 07-11-2024, 04:12 PM
RE: SABA 400 Automatic Stereo 11 - by RadioSvit - 07-11-2024, 04:24 PM
RE: SABA 400 Automatic Stereo 11 - by RadioSvit - 07-11-2024, 04:27 PM
RE: SABA 400 Automatic Stereo 11 - by RadioSvit - 07-11-2024, 04:36 PM
RE: SABA 400 Automatic Stereo 11 - by Jayce - 07-11-2024, 05:43 PM
RE: SABA 400 Automatic Stereo 11 - by morzh - 07-11-2024, 07:14 PM
RE: SABA 400 Automatic Stereo 11 - by RadioSvit - 07-12-2024, 12:41 PM
RE: SABA 400 Automatic Stereo 11 - by Jayce - 07-12-2024, 04:56 PM
RE: SABA 400 Automatic Stereo 11 - by morzh - 07-12-2024, 08:04 PM
RE: SABA 400 Automatic Stereo 11 - by MrFixr55 - 07-13-2024, 09:43 AM
RE: SABA 400 Automatic Stereo 11 - by Jayce - 07-13-2024, 04:52 PM
RE: SABA 400 Automatic Stereo 11 - by Arran - 07-17-2024, 05:01 PM
RE: SABA 400 Automatic Stereo 11 - by RadioSvit - 07-18-2024, 02:51 PM
RE: SABA 400 Automatic Stereo 11 - by Jayce - 07-19-2024, 11:20 AM
RE: SABA 400 Automatic Stereo 11 - by Jayce - 07-22-2024, 01:38 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Cannot Adjust an IF Transformer’s cores
The abilities of our 'Phorum Pholks" never ceases to amaze me! Fantastic fabrication, Joseph! I'm waiting now for...GarySP — 08:27 PM
PT-6 antenna connections
Thanks. I never realized that was a notch noted in the schematic as described. I’ll recheck my wiring.bridkarl — 08:13 PM
Cannot Adjust an IF Transformer’s cores
Thank you! I was quite new to the Phorum when I started this post, so I feel like it might be advantageous to publish a ...jrblasde — 08:07 PM
PT-6 antenna connections
Notice in the schematic the notch at the bottom of the antenna coil is between pins 3 & 4. Yes, pin 6 of the 7C6 is...RodB — 07:34 PM
bridkarl
I have two PT-6 chassis. On both there is a blue wire that runs from the above chassis transformer to pin 6 of 7C6. So t...bridkarl — 07:23 PM
Cannot Adjust an IF Transformer’s cores
Joseph, now you are an engineer!!RodB — 06:37 PM
PT-6 antenna connections
Hi, reading your explanation I can see the confusion. If you take it one connection at a time it should result in a desi...RodB — 06:34 PM
Cannot Adjust an IF Transformer’s cores
It works! I received the PCBs this morning in the mail, and put everything together. I reused the base from the original...jrblasde — 04:32 PM
PT-6 antenna connections
I seem to have lost my way on this PT-6. I see the antenna aerial transformer schematic - I’m reading pins 1 through ...bridkarl — 12:30 PM
40-150 General questions
Good thing you're a good electrician ... the pictures show a lot of rewiring in your future! Take care and BE HEALTHY!...GarySP — 11:52 AM

[-]
Who's Online
There are currently 3770 online users. [Complete List]
» 2 Member(s) | 3768 Guest(s)
AvatarAvatar

>