PT-6 antenna

Thread Rating:

PT-6 antenna

bridkarl
Member

Posts: 182
Threads: 39
Joined: May 2023
City: Pocatello State, Province, Country: idaho

08-04-2024, 09:46 AM

I checked and the 7a8 oscillator tube shows a short. That’s probably the problem. Thanks

Find

« Next Oldest | Next Newest »

Messages In This Thread

PT-6 antenna - by bridkarl - 08-03-2024, 01:35 PM

RE: PT-6 antenna - by RodB - 08-03-2024, 01:58 PM

RE: PT-6 antenna - by bridkarl - 08-04-2024, 09:46 AM

462ron - by 462ron - 08-05-2024, 08:04 AM

RE: PT-6 antenna - by bridkarl - 08-06-2024, 08:53 PM

RE: PT-6 antenna - by MrFixr55 - 08-08-2024, 09:37 PM

Users browsing this thread: 1 Guest(s)

Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

Who's Online

There are currently 6479 online users. [Complete List]
» 2 Member(s) | 6477 Guest(s)