Philco 38-7 Speaker

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Philco 38-7 Speaker

Radioroslyn
Phorum Expert

Posts: 7,286
Threads: 268
Joined: Dec 2009
City: Roslyn Pa

08-19-2024, 06:58 PM

You'll need an opt to match the 6F6/42 to VC vs the 1J6. And something to replace or act as the field coil. The 1J6's output is somewhat less than the 6F6 so wouldn't be a good idea to try the the opt on the spk. The current rating is going to be too low and the load resistance too high.

Replacing the spkr w/a modern one is the same. Find an opt 5k to vc and something to replace the fc.

https://philcoradio.com/library/download...%20280.pdf

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry

(This post was last modified: 08-19-2024, 07:08 PM by Radioroslyn.)

Find

« Next Oldest | Next Newest »

Messages In This Thread

Philco 38-7 Speaker - by tludka - 08-19-2024, 03:52 PM

RE: Philco 38-7 Speaker - by Radioroslyn - 08-19-2024, 06:58 PM

RE: Philco 38-7 Speaker - by tludka - 08-22-2024, 01:00 PM

RE: Philco 38-7 Speaker - by MrFixr55 - 08-22-2024, 10:59 PM

RE: Philco 38-7 Speaker - by tludka - 08-23-2024, 12:24 PM

RE: Philco 38-7 Speaker - by MrFixr55 - 08-23-2024, 04:40 PM

RE: Philco 38-7 Speaker - by MrFixr55 - 08-23-2024, 04:51 PM

RE: Philco 38-7 Speaker - by tludka - 08-23-2024, 05:22 PM

RE: Philco 38-7 Speaker - by MrFixr55 - 08-24-2024, 09:03 AM

RE: Philco 38-7 Speaker - by tludka - 6 hours ago

RE: Philco 38-7 Speaker - by morzh - 5 hours ago

RE: Philco 38-7 Speaker - by tludka - 4 hours ago

RE: Philco 38-7 Speaker - by morzh - 3 hours ago

RE: Philco 38-7 Speaker - by tludka - 55 minutes ago

View a Printable Version

Users browsing this thread: 2 Guest(s)

Recent Posts
Philco 38-7 Oscillation
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 11:16 PM
Philco 38-7 Speaker
I know that when I first started working on this radio, I did not even have a speaker. Once I finally found one it was n...tludka — 11:00 PM
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone, As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic. This radio had a 8" Zenith speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM

Who's Online

There are currently 4055 online users. [Complete List]
» 3 Member(s) | 4052 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me