Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 38-7 Speaker
#3

I noticed in the Philco Library / Speakers that an H20 is listed for models - "Central Contact System." With a "1000 Impedance online" listed for the output tube. Can anyone clear up my confusion on the Model and output tube references?


Messages In This Thread
Philco 38-7 Speaker - by tludka - 08-19-2024, 03:52 PM
RE: Philco 38-7 Speaker - by Radioroslyn - 08-19-2024, 06:58 PM
RE: Philco 38-7 Speaker - by tludka - 08-22-2024, 01:00 PM
RE: Philco 38-7 Speaker - by MrFixr55 - 08-22-2024, 10:59 PM
RE: Philco 38-7 Speaker - by tludka - 08-23-2024, 12:24 PM
RE: Philco 38-7 Speaker - by MrFixr55 - 08-23-2024, 04:40 PM
RE: Philco 38-7 Speaker - by MrFixr55 - 08-23-2024, 04:51 PM
RE: Philco 38-7 Speaker - by tludka - 08-23-2024, 05:22 PM
RE: Philco 38-7 Speaker - by MrFixr55 - 08-24-2024, 09:03 AM
RE: Philco 38-7 Speaker - by tludka - 6 hours ago
RE: Philco 38-7 Speaker - by morzh - 5 hours ago
RE: Philco 38-7 Speaker - by tludka - 4 hours ago
RE: Philco 38-7 Speaker - by morzh - 3 hours ago
RE: Philco 38-7 Speaker - by tludka - 51 minutes ago



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 38-7 Oscillation
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 11:16 PM
Philco 38-7 Speaker
I know that when I first started working on this radio, I did not even have a speaker. Once I finally found one it was n...tludka — 11:00 PM
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM

[-]
Who's Online
There are currently 4057 online users. [Complete List]
» 2 Member(s) | 4055 Guest(s)
AvatarAvatar

>