Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Restoring Philco 38-12 in a wood cabinet
#11

Have just finished the alignment and shot a short video of the radio receiving with a short 7-ft wire in the basement of my house.
The reception is fine.
The radio was aligned previously and was reasonably close to being aligned. I followed the instruction for initial setting of the pointer, which has to be 1/16" below the three-line frame top, and this is what II had to compensate (mostly) when adjusting the padders: the needle was previously set exactly at the lower end of the dial.

This is the link to the video of it receiving.

https://m.youtube.com/watch?v=CF2AzpNNrn...e=youtu.be

People who do not drink, do not smoke, do not eat red meat will one day feel really stupid lying there and dying from nothing.


Messages In This Thread
RE: Restoring Philco 38-12 in a wood cabinet - by morzh - 08-31-2024, 11:47 AM



Users browsing this thread: 4 Guest(s)
[-]
Recent Posts
The list of my radio & TV collection!
Mike;   There was a radio that the British issued to their agents which used a regenerative circuit, and not surprising...Arran — 03:17 AM
the worlds largest CRT Television,, not philco - KX45ED1
i still have my Sony Trinitron TV. Didn't have the heart to toss it. My first new color TV. Bought it at Wiz. $200. In 1...morzh — 08:56 PM
the worlds largest CRT Television,, not philco - KX45ED1
I saw that on YouTube just this week! What an incredibly massive CRT, and what luck that it was discovered and saved.jrblasde — 08:19 PM
the worlds largest CRT Television,, not philco - KX45ED1
the worlds largest CRT Television,, not philco - KX45ED1 sorry this is  not philco so if its in the wrong location,, ei...jcassity — 07:25 PM
Custom Hammond Power Transformer
Another trick I learned of to remove any of the thick crusty rust that our little rodent friends tend to leave on a radi...Arran — 05:31 PM
Custom Hammond Power Transformer
I suggest stripping all electronics, including sockets, from the chassis. That way you have a completely free hand to us...DaleHCook — 04:19 PM
Custom Hammond Power Transformer
I do already have an isolation transformer. I got that before aligning my 49-906 since it’s an AC/DC set. I didn’t dare ...jrblasde — 04:10 PM
Custom Hammond Power Transformer
Very nice work on that transformer! Now you can move on to the next steps. +1 on not using the dimmer control. They do i...TV MAN — 04:02 PM
Philco 70 antenna lead
I see in that picture that the power cord is held next to the chassis with the clip that in mine holds the antenna lead....Jim Dutridge — 03:55 PM
Dynaco PAT 4
I am starting to hear a small amount of 120hz filter hum, which I didn't hear in my headphones, so it's time to address ...TV MAN — 03:47 PM

[-]
Who's Online
There are currently no members online.

>