Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Looking for place to donate unique Philco Philco J-1930 Prototype
#11

Thx for the description. I thought that it had to have a single 10 - 12" Sensor.
Congrats on restoring the GE and VM changer. Back in the 70s and 80s, both radio Shack and Lafayette sold a small packaged preamp for magnetic cartridges.
I did that on a couple of friends' console phonos, replacing the ceramic or crystal with a Shure M3D or M7D cartridge. Big improvement ofver a ceramic and extremely big improvement over a Crstal cartridge. (Lafayette's main store and clearance center was within bicycle distance from my home, what fun!!)

See if Salvation Army or St Vincent DePaul will accept it as a donation. SVDP sells furniture and the profits go to their charitable programs. Mine had a Fisher console. Unfortunately, I had neither the room nor the money for it (They knew what it was worth and it did sell.

"Do Justly, love Mercy and walk humbly with your God"- Micah 6:8
Best Regards, 

MrFixr55





Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
Looking for verification of correct schematic.
Definitely 870044RossH — 01:12 PM
12' Philco
Wonder if the chassis was big too.daveone23 — 12:38 PM
Philco 38-2 Automatic Tuning
Hi Ron, I have sent Radio Daze my concerns with the dial so I guess we will see. They used my original to make the repro...dconant — 12:27 PM
Hickok AC51 tube tester
How does the  5W4 and 83 tube filaments get fed?martinj — 12:25 PM
462ron
Hi Dan, your original dial appears to be lighter, easier to allow light through. My original is similar except it’s crac...462ron — 12:07 PM
Philco 38-2 Automatic Tuning
I received my new 38-2 dial. I'm a little disappointed. As you can see in the picture the blues have a white shadow. The...dconant — 11:13 AM
Philco 38-2 Low Volume
I have been playing my 38-2 for a while now and it is doing very well. I did have to replace the 6A8 (osc) as it develop...dconant — 11:03 AM
Philco Speaker Spider
Hello, Does anyone with a 3 D printer make the spiders for those old Philco speakers? That might be a good idea for some...dconant — 09:41 AM
Philco 16B Parts
Hello, I'm looking to buy a 16B but I'm not so sure of what I am looking at. First as seen from the picture it looks lik...dconant — 09:17 AM
Looking for verification of correct schematic.
Klondike98, Thank you. I'll double check that SN and get back to you. GarySP, Thank you for the schematic.RossH — 12:13 AM

[-]
Who's Online
There are currently 1501 online users. [Complete List]
» 3 Member(s) | 1498 Guest(s)
AvatarAvatarAvatar

>