10-11-2024, 01:25 PM
Here's my thought:
My requirements for the bushing are:
Bore: 7mm (7.1mm) - 0.28"
OD: 9mm (9.3mm) - 0.36"
Amazon has this
https://www.amazon.com/Qimoo-Flanged-Bea...r=1-2&th=1
M8 Bore, 10.6mm OD
Or this
https://www.amazon.com/HARFINGTON-Flange...r=1-3&th=1
8mm Bore, 10mm OD
What if I buy this, cut some 2-3mm slit and make a split bushing out of it, that just might fit.
I am not, after all, using it as a bearing, it is a sleeve for the shaft.
What do you guys think?
My requirements for the bushing are:
Bore: 7mm (7.1mm) - 0.28"
OD: 9mm (9.3mm) - 0.36"
Amazon has this
https://www.amazon.com/Qimoo-Flanged-Bea...r=1-2&th=1
M8 Bore, 10.6mm OD
Or this
https://www.amazon.com/HARFINGTON-Flange...r=1-3&th=1
8mm Bore, 10mm OD
What if I buy this, cut some 2-3mm slit and make a split bushing out of it, that just might fit.
I am not, after all, using it as a bearing, it is a sleeve for the shaft.
What do you guys think?
People who do not drink, do not smoke, do not eat red meat will one day feel really stupid lying there and dying from nothing.