Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Hickok 288x
#20

I put the scope on pin 8 of the 6sn7 and read something but i had to crank the scope WAY down to 10m volts and 10ms time. Read the same on the probe. Volts on tube plates are hit and miss.
6c4 = -.6vdc
6sn7 v2 = 243vdc
6sn7 v3 = 195vdc
6sj7 = 260vdc
6sg7 = 11vdc
Why does the pic of the 6sn7s look different?
Whats next to check?


Attached Files Image(s)
       


Messages In This Thread
Hickok 288x - by daveone23 - 10-14-2024, 02:27 PM
RE: Hickok 288x - by MrFixr55 - 10-14-2024, 03:50 PM
RE: Hickok 288x - by daveone23 - 10-14-2024, 04:40 PM
RE: Hickok 288x - by daveone23 - 10-14-2024, 06:27 PM
RE: Hickok 288x - by MrFixr55 - 10-14-2024, 06:43 PM
RE: Hickok 288x - by MrFixr55 - 10-14-2024, 07:04 PM
RE: Hickok 288x - by radiorich - 10-14-2024, 09:24 PM
RE: Hickok 288x - by daveone23 - 10-15-2024, 07:05 AM
462ron - by 462ron - 10-15-2024, 07:37 AM
RE: Hickok 288x - by daveone23 - 10-15-2024, 09:01 AM
RE: Hickok 288x - by daveone23 - 10-15-2024, 02:50 PM
RE: Hickok 288x - by daveone23 - 10-15-2024, 03:36 PM
462ron - by 462ron - 10-16-2024, 06:43 AM
RE: Hickok 288x - by daveone23 - 10-16-2024, 03:33 PM
RE: Hickok 288x - by MrFixr55 - 10-16-2024, 08:57 PM
RE: Hickok 288x - by daveone23 - 10-17-2024, 06:23 AM
RE: Hickok 288x - by daveone23 - 10-22-2024, 03:59 PM
RE: Hickok 288x - by MrFixr55 - 10-22-2024, 07:10 PM
RE: Hickok 288x - by daveone23 - 10-23-2024, 07:44 AM
RE: Hickok 288x - by daveone23 - 10-23-2024, 05:54 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Restoring Philco 37-604C
So, I put the wires back to the power switch, plugged it in, slowly increasing the Variac output...nothing. No DC, not e...morzh — 08:40 PM
Delco car radio Peko vibrator converstion issues
Rich, There is an Australian website (Cool386.com) that has much useful info regarding repair and restoration of vibr...Joe Rossi — 07:29 PM
Jackson 715 not working
Mrfixr55, its working now. I cleaned the switches and sockets with spray cleaner. Thanks for helping on this one.daveone23 — 06:26 PM
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM

[-]
Who's Online
There are currently no members online.

>