Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 643 color scheme and modification
#24

I hadn't even thought about the pilot lamp until you guys mentioned it. Yes, it is on all the time. I just wish there was a mask that only illuminated the active band rather than the whole dial.

Ron Ramirez Wrote:Good luck...I am sure it will turn out as well as my 650B did...maybe even better. Icon_smile

We'll see Icon_wink

The sides and top are pretty tight grained so I did a few rounds of shellac and sanding rather than use grain filler.

Then on to the front panel where I used Constantine's walnut paste filler. I diluted it about 50/50 with mineral spirits and worked it in well with a small brush.

Once it thickened up and got hazy, I wiped the excess off going across the grain with burlap.

So far so good Icon_smile
[Image: http://farm7.static.flickr.com/6133/5989...5210_z.jpg]

[Image: http://farm7.static.flickr.com/6132/5989...7206_z.jpg]

[Image: http://farm7.static.flickr.com/6141/5989...4359_z.jpg]

[Image: http://farm7.static.flickr.com/6132/5989...0793_z.jpg]


Messages In This Thread
Re: Philco 643 color scheme and modification - by Bob Andersen - 07-29-2011, 11:09 PM



Users browsing this thread: 7 Guest(s)
[-]
Recent Posts
Shadow Meter Bulb
Any 6.3 volt pilot light will work. I would use the brightest one I could find in my workroom. Be sure the dial is clean...RodB — 10:45 AM
HiFi (Chifi) tube amp build - but my own design.
Tim, nice write up and thanks for sharing !! Sincerely Richardradiorich — 02:47 AM
HiFi (Chifi) tube amp build - but my own design.
Well, this was a real "Hum-Dinger" :lol: ! This will be kinda long, but hopefully it will help others having t...TV MAN — 01:55 AM
Shadow Meter Bulb
Phorum members, I am trying to find the bulb # for PHILCO Shadow Meter part number 45-2180 that is from a 37-640 chassis...georgetownjohn — 06:53 PM
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM

[-]
Who's Online
There are currently 7829 online users. [Complete List]
» 2 Member(s) | 7827 Guest(s)
AvatarAvatar

>