Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

B Batt Senior Clips
#8

[attachment=31096][attachment=31097]

There is a lot more of the larger than the smaller.

There is also a lot of male snaps with attached crimp lugs but no female.

Chas

Pliny the younger
“nihil novum nihil varium nihil quod non semel spectasse sufficiat”


Messages In This Thread
B Batt Senior Clips - by slford310 - 10-24-2024, 03:13 PM
RE: B Batt Senior Clips - by Chas - 10-24-2024, 05:20 PM
RE: B Batt Senior Clips - by slford310 - 10-24-2024, 09:18 PM
RE: B Batt Senior Clips - by Chas - 10-24-2024, 11:33 PM
RE: B Batt Senior Clips - by slford310 - 10-24-2024, 11:37 PM
RE: B Batt Senior Clips - by Chas - 10-24-2024, 11:55 PM
RE: B Batt Senior Clips - by slford310 - 10-25-2024, 09:40 AM
RE: B Batt Senior Clips - by Chas - 10-25-2024, 01:52 PM



Users browsing this thread: 4 Guest(s)
[-]
Recent Posts
Looking for verification of correct schematic.
Definitely 870044RossH — 01:12 PM
12' Philco
Wonder if the chassis was big too.daveone23 — 12:38 PM
Philco 38-2 Automatic Tuning
Hi Ron, I have sent Radio Daze my concerns with the dial so I guess we will see. They used my original to make the repro...dconant — 12:27 PM
Hickok AC51 tube tester
How does the  5W4 and 83 tube filaments get fed?martinj — 12:25 PM
462ron
Hi Dan, your original dial appears to be lighter, easier to allow light through. My original is similar except it’s crac...462ron — 12:07 PM
Philco 38-2 Automatic Tuning
I received my new 38-2 dial. I'm a little disappointed. As you can see in the picture the blues have a white shadow. The...dconant — 11:13 AM
Philco 38-2 Low Volume
I have been playing my 38-2 for a while now and it is doing very well. I did have to replace the 6A8 (osc) as it develop...dconant — 11:03 AM
Philco Speaker Spider
Hello, Does anyone with a 3 D printer make the spiders for those old Philco speakers? That might be a good idea for some...dconant — 09:41 AM
Philco 16B Parts
Hello, I'm looking to buy a 16B but I'm not so sure of what I am looking at. First as seen from the picture it looks lik...dconant — 09:17 AM
Looking for verification of correct schematic.
Klondike98, Thank you. I'll double check that SN and get back to you. GarySP, Thank you for the schematic.RossH — 12:13 AM

[-]
Who's Online
There are currently no members online.

>