Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco signal generator model 088. Or not??
#1

I bought the signal generator in the post below but can't identify it. The schematic for a model 088 pretty much matches the circuitry in this one, including the single tube, a 1C6. But this one has a DC power supply built in, while the model 088 needed 2 batteries, a 45 V and a 22.5V. Plus a couple 1.5V batteries, which this one does require. Anyone know what I have here? The closest match in the Philco library is the model 088, link below.
Maybe someone did a remarkably good job of adding the power supply??, because it looks to be factory made.
Thanks

For sale listing: https://philcoradio.com/phorum/showthread.php?tid=25318

Manual for the 088: http://www.myvintagetv.com/Apple%20PDF%2...co_088.pdf

Philco Radio Test Equipment Manual in the philco library: https://philcoradio.com/library/index.ph...nual-1944/


Messages In This Thread
Philco signal generator model 088. Or not?? - by fenbach - 10-30-2024, 07:22 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Looking for verification of correct schematic.
Definitely 870044RossH — 01:12 PM
12' Philco
Wonder if the chassis was big too.daveone23 — 12:38 PM
Philco 38-2 Automatic Tuning
Hi Ron, I have sent Radio Daze my concerns with the dial so I guess we will see. They used my original to make the repro...dconant — 12:27 PM
Hickok AC51 tube tester
How does the  5W4 and 83 tube filaments get fed?martinj — 12:25 PM
462ron
Hi Dan, your original dial appears to be lighter, easier to allow light through. My original is similar except it’s crac...462ron — 12:07 PM
Philco 38-2 Automatic Tuning
I received my new 38-2 dial. I'm a little disappointed. As you can see in the picture the blues have a white shadow. The...dconant — 11:13 AM
Philco 38-2 Low Volume
I have been playing my 38-2 for a while now and it is doing very well. I did have to replace the 6A8 (osc) as it develop...dconant — 11:03 AM
Philco Speaker Spider
Hello, Does anyone with a 3 D printer make the spiders for those old Philco speakers? That might be a good idea for some...dconant — 09:41 AM
Philco 16B Parts
Hello, I'm looking to buy a 16B but I'm not so sure of what I am looking at. First as seen from the picture it looks lik...dconant — 09:17 AM
Looking for verification of correct schematic.
Klondike98, Thank you. I'll double check that SN and get back to you. GarySP, Thank you for the schematic.RossH — 12:13 AM

[-]
Who's Online
There are currently no members online.

>