Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 38-2 Automatic Tuning
#9

Seems more like a selling point to me. I too have have a Philco with the Cone-Centric tuning. Hopefully I will get the chassis back in the cabinet soon and then I will post some pictures. Cabinet needed stripping but it is finished now. I didn't use stripper I scrapped the finish off with a small paint scrapper which to me is a lot less messy. Worked very well.


Messages In This Thread
Philco 38-2 Automatic Tuning - by dconant - 11-03-2024, 11:51 AM
RE: Philco 38-2 Automatic Tuning - by dconant - 11-03-2024, 01:11 PM
RE: Philco 38-2 Automatic Tuning - by morzh - 11-03-2024, 02:42 PM
RE: Philco 38-2 Automatic Tuning - by dconant - 11-04-2024, 08:22 AM
RE: Philco 38-2 Automatic Tuning - by radiorich - 11-04-2024, 09:14 AM
RE: Philco 38-2 Automatic Tuning - by morzh - 11-04-2024, 10:50 AM
RE: Philco 38-2 Automatic Tuning - by RodB - 11-04-2024, 11:00 AM
RE: Philco 38-2 Automatic Tuning - by morzh - 11-04-2024, 11:55 AM
RE: Philco 38-2 Automatic Tuning - by dconant - 11-04-2024, 01:17 PM
RE: Philco 38-2 Automatic Tuning - by morzh - 11-04-2024, 03:20 PM
RE: Philco 38-2 Automatic Tuning - by radiorich - 11-04-2024, 03:56 PM
RE: Philco 38-2 Automatic Tuning - by dconant - 11-04-2024, 04:13 PM
RE: Philco 38-2 Automatic Tuning - by rfeenstra - 11-05-2024, 01:20 AM
RE: Philco 38-2 Automatic Tuning - by poulsbobill - 11-05-2024, 12:16 PM
RE: Philco 38-2 Automatic Tuning - by dconant - 11-05-2024, 06:45 PM
RE: Philco 38-2 Automatic Tuning - by dconant - 11-11-2024, 12:39 PM
462ron - by 462ron - 11-12-2024, 08:58 AM
RE: Philco 38-2 Automatic Tuning - by dconant - 11-12-2024, 09:23 AM
462ron - by 462ron - 11-12-2024, 09:40 AM
RE: Philco 38-2 Automatic Tuning - by dconant - 11-12-2024, 09:51 AM
462ron - by 462ron - 11-12-2024, 10:34 AM
RE: Philco 38-2 Automatic Tuning - by dconant - 11-21-2024, 11:13 AM
462ron - by 462ron - 11-21-2024, 12:07 PM
RE: Philco 38-2 Automatic Tuning - by dconant - 11-21-2024, 12:27 PM
RE: Philco 38-2 Automatic Tuning - by morzh - 11-21-2024, 08:11 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently no members online.

>