Philco 70 antenna lead
|
Seems odd to me that Philco would run the antenna lead over top of the filter caps and the power cord. Would that not in...Jim Dutridge — 01:54 PM |
Custom Hammond Power Transformer
|
Joseph,
Very well done!
Because the radio has some chassis corrosion, do solder or re-solder all chassis connecti...Chas — 12:50 PM |
Philco 60 restoration
|
Arran
The control is original. The wiper is some sort of round brass plate, that probably just digs into the carbon e...morzh — 12:28 PM |
Model 41-280 5 dials
|
Have fun.
This is my thread on that same radio. Bought in 2014, restored in 2017.
Be prepared to deal with rubb...morzh — 12:24 PM |
My first Philco radio.
|
Boy this party ready DIEDOldie Goldie — 12:01 PM |
Model 41-280 5 dials
|
Welcome to the Phorum, blake3801! The right four knobs are correct for this set. The fifth knob on the left is an add-...GarySP — 10:34 AM |
Model 41-280 5 dials
|
Hey everyone, new to the classic radio game. I’m being gifted a Model 41-280 from the in-laws, and from what I’ve seen o...blake3801 — 01:40 AM |
Philco 60 restoration
|
Mike;
So if you check the resistance from end to end the volume pot reads 3 meg Ohm? I could see 1 meg maybe, if some...Arran — 11:59 PM |
40-180 electrical troubleshooting
|
I isolated the circuit. And I’m still blowing 60 resistor. I just ordered the 84 rectifier tube. To see if that’s the is...winamp920@yahoo.com — 10:58 PM |
Philco 60 restoration
|
After having attached the line cord, I checked the switch and the volume pot again. That is, I did check the switch befo...morzh — 10:34 PM |