Philco 41-608 changer coupler

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Philco 41-608 changer coupler

alangard
Junior Member

Posts: 4
Threads: 2
Joined: Nov 2024
City: Bartlett State, Province, Country: Illinois

11-21-2024, 06:29 PM

I am working on a Philco 41-608 with the gear-driven changer. The coupling (#35-2220) between the motor assembly and the idler wheel shaft was made of pot metal and is now in 'kit form'.

Is there a source for a ready-made replacement? Are there any designs available for making a replacement coupler?

Thanks!

Find

« Next Oldest | Next Newest »

Messages In This Thread

Philco 41-608 changer coupler - by alangard - 11-21-2024, 06:29 PM

RE: Philco 41-608 changer coupler - by morzh - 11-21-2024, 08:09 PM

RE: Philco 41-608 changer coupler - by alangard - 11-21-2024, 08:31 PM

RE: Philco 41-608 changer coupler - by morzh - 11-21-2024, 09:38 PM

RE: Philco 41-608 changer coupler - by alangard - 11-22-2024, 05:07 PM

RE: Philco 41-608 changer coupler - by morzh - 11-22-2024, 05:20 PM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

Who's Online

There are currently 6517 online users. [Complete List]
» 6 Member(s) | 6511 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me