Philco 60 Squealing

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Philco 60 Squealing

dconant
Member

Posts: 134
Threads: 26
Joined: Jun 2022
City: Marion State, Province, Country: NY

10 hours ago

I have taken out the 2nd IF and found a problem or not. I believe the coils are litz wire. There is a very small strand tied to the wire leading out of the coil. That strand it a lot smaller than the coil wire. Problem is the coil wire is less than an inch long and is the inside of the coil. How am I ever going to solder that? I'm thinking that single strand might be my squealing. I have never tried to solder litz wire. I am concerned I may burn up the wire and then the coil is done for. Any suggestions?

Find

« Next Oldest | Next Newest »

Messages In This Thread

Philco 60 Squealing - by dconant - 11-25-2024, 10:55 AM

RE: Philco 60 Squealing - by Chas - 11-25-2024, 01:24 PM

RE: Philco 60 Squealing - by dconant - 10 hours ago

RE: Philco 60 Squealing - by morzh - 7 hours ago

RE: Philco 60 Squealing - by dconant - 6 hours ago

RE: Philco 60 Squealing - by Chas - 5 hours ago

RE: Philco 60 Squealing - by fenbach - 3 hours ago

View a Printable Version

Users browsing this thread: 2 Guest(s)

Recent Posts
Philco 38-7 Oscillation
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 11:16 PM
Philco 38-7 Speaker
I know that when I first started working on this radio, I did not even have a speaker. Once I finally found one it was n...tludka — 11:00 PM
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone, As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic. This radio had a 8" Zenith speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM

Who's Online
There are currently no members online.

Login
Username:
Password:	Lost Password?
	Remember me