Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

philco 610
#8

I just stick the cap in turn the block over and solder the leads. Nobody can see under the blocks and potting is not needed.

Kind regards,
Terry
http://home.comcast.net/~suptjud/
"Life is simpler when you plow around the stump."


Messages In This Thread
philco 610 - by philco fan - 07-02-2006, 05:21 PM
Re: philco 610 - by n9vu - 07-03-2006, 05:59 AM
[No subject] - by Terry Burns - 07-03-2006, 09:50 AM
610 recapping - by AI2V - 07-03-2006, 10:04 AM
[No subject] - by Jimony - 07-03-2006, 08:20 PM
[No subject] - by philco fan - 07-03-2006, 10:29 PM
Re: 610 recapping - by n9vu - 07-04-2006, 08:34 PM
[No subject] - by Terry Judkins - 07-04-2006, 09:20 PM
[No subject] - by philco fan - 07-07-2006, 12:55 AM
[No subject] - by Terry Burns - 07-07-2006, 01:46 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM

[-]
Who's Online
There are currently 4289 online users. [Complete List]
» 4 Member(s) | 4285 Guest(s)
AvatarAvatarAvatarAvatar

>