Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 38-690 input jack
#7

mr. Fixr:

One thing I wouldn't use it for is a guitar, unless acoustic only. Guitar amps are designed a tad differently, and clipping and distortion are intentional.


RSK20m3:

This is where I would agree with Mr. Fixr. Yes, AM sounds very good on 38-690, but, at least in theory, putting the same signal through mo-dem conversion vs amplifying directly, as a minimum, does not improve anything.
AM Radios never reached the quality of direct HiFi.
FM came close. But even then...

People who do not drink, do not smoke, do not eat red meat will one day feel really stupid lying there and dying from nothing.


Messages In This Thread
Philco 38-690 input jack - by supertech - 12-17-2024, 10:04 PM
RE: Philco 38-690 input jack - by MrFixr55 - 12-18-2024, 11:12 AM
RE: Philco 38-690 input jack - by supertech - 12-18-2024, 11:23 AM
RE: Philco 38-690 input jack - by MrFixr55 - 12-19-2024, 09:50 AM
RE: Philco 38-690 input jack - by radiorich - 12-19-2024, 10:33 AM
RE: Philco 38-690 input jack - by morzh - 11 hours ago



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
250 ohm micamold resistor
It's less than ten percent over. It's OK.RodB — 11:07 PM
Custom Hammond Power Transformer
Boy howdy, that’s some nice custom testing equipment! I really do need to invest in a variac. I also have a tube tester ...jrblasde — 10:46 PM
250 ohm micamold resistor
Thought I'd ask the experts. This is a Philco 38-12CI.  The 250 ohm resistor comes out to 261 ohms. I'm not sure what th...DJW — 10:35 PM
My first Philco radio.
Maybe it's time to replace the 3 ball bearings. I've done it on a few sets to lessen the roughness in the tuning.Radioroslyn — 10:04 PM
My first Philco radio.
I have a theory. One of the three big balls bearings came out while the other two wouldn't slide out. I didn't think it...Oldie Goldie — 09:21 PM
My first Philco radio.
I don't get this. Is the spring too strong or gotten weak and that's why the ball bearings are losing the grasp on the i...Oldie Goldie — 08:58 PM
My first Philco radio.
I put it all to bed for the night. In the morning I'm going to try to get the three big balls bearings out and see what'...Oldie Goldie — 08:46 PM
My first Philco radio.
I had no idea the heart of the tuning mechanism was based on such an unnecessarily complicated fragile design. With such...Oldie Goldie — 08:31 PM
My first Philco radio.
I followed the instructions on the link another member provided. Carefully took the shaft assembly apart. One screw was ...Oldie Goldie — 07:40 PM
91H Code 126 Restore
Hi Nick, will heat to remove the tar but is it recommended to do this with the metal-cased condensers?  They have a ca...Radioroslyn — 06:27 PM

[-]
Who's Online
There are currently 1283 online users. [Complete List]
» 2 Member(s) | 1281 Guest(s)
AvatarAvatar

>