Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

My first Philco radio.
#12

I love it. I must have at least two laying on my workroom floor somewhere.


Messages In This Thread
My first Philco radio. - by Oldie Goldie - Yesterday, 08:10 AM
RE: My first Philco radio. - by jrblasde - Yesterday, 10:59 AM
RE: My first Philco radio. - by klondike98 - Yesterday, 03:27 PM
RE: My first Philco radio. - by morzh - Yesterday, 05:14 PM
RE: My first Philco radio. - by Oldie Goldie - Yesterday, 06:12 PM
RE: My first Philco radio. - by Oldie Goldie - Yesterday, 06:21 PM
RE: My first Philco radio. - by Oldie Goldie - Yesterday, 06:31 PM
RE: My first Philco radio. - by morzh - Yesterday, 08:19 PM
RE: My first Philco radio. - by klondike98 - Yesterday, 08:53 PM
RE: My first Philco radio. - by RodB - 11 hours ago
RE: My first Philco radio. - by morzh - 11 hours ago
RE: My first Philco radio. - by RodB - 11 hours ago



Users browsing this thread: 1 Invisible User(s), 1 Guest(s)
[-]
Recent Posts
250 ohm micamold resistor
It's less than ten percent over. It's OK.RodB — 11:07 PM
Custom Hammond Power Transformer
Boy howdy, that’s some nice custom testing equipment! I really do need to invest in a variac. I also have a tube tester ...jrblasde — 10:46 PM
250 ohm micamold resistor
Thought I'd ask the experts. This is a Philco 38-12CI.  The 250 ohm resistor comes out to 261 ohms. I'm not sure what th...DJW — 10:35 PM
My first Philco radio.
Maybe it's time to replace the 3 ball bearings. I've done it on a few sets to lessen the roughness in the tuning.Radioroslyn — 10:04 PM
My first Philco radio.
I have a theory. One of the three big balls bearings came out while the other two wouldn't slide out. I didn't think it...Oldie Goldie — 09:21 PM
My first Philco radio.
I don't get this. Is the spring too strong or gotten weak and that's why the ball bearings are losing the grasp on the i...Oldie Goldie — 08:58 PM
My first Philco radio.
I put it all to bed for the night. In the morning I'm going to try to get the three big balls bearings out and see what'...Oldie Goldie — 08:46 PM
My first Philco radio.
I had no idea the heart of the tuning mechanism was based on such an unnecessarily complicated fragile design. With such...Oldie Goldie — 08:31 PM
My first Philco radio.
I followed the instructions on the link another member provided. Carefully took the shaft assembly apart. One screw was ...Oldie Goldie — 07:40 PM
91H Code 126 Restore
Hi Nick, will heat to remove the tar but is it recommended to do this with the metal-cased condensers?  They have a ca...Radioroslyn — 06:27 PM

[-]
Who's Online
There are currently 1536 online users. [Complete List]
» 3 Member(s) | 1533 Guest(s)
AvatarAvatarAvatar

>