1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco 70 antenna lead
Dave Schings
New Member
*
Posts: 1
Threads: 0
Joined: Dec 2023
City: Peoria State, Province, Country: IL
#4

12-26-2024, 04:30 PM
My wire runs the way yours does, Jim. From the antenna, to the clip under the right rear chassis mount, then to the volume control.

Dave
Find
« Next Oldest | Next Newest »


Messages In This Thread
Philco 70 antenna lead - by Jim Dutridge - 12-25-2024, 01:54 PM
RE: Philco 70 antenna lead - by morzh - 12-25-2024, 02:21 PM
RE: Philco 70 antenna lead - by Jim Dutridge - 12-25-2024, 03:55 PM
RE: Philco 70 antenna lead - by Dave Schings - 12-26-2024, 04:30 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
(Safely) Removing Rust from Chassis
You have to be selective with the rust removal chemicals and the metal. A while back I put a piece of rusted pot metal i...RodB — 12:17 AM
Philco 60 restoration
No. The padders on the side, small caps in parallel to each section, contain mica. Those two brass screw/nuts on the sid...morzh — 11:37 PM
Philco 60 restoration
I was unaware that these air tuning capacitors contained any mica. Are the individual stator and rotor plates coated in ...jrblasde — 11:27 PM
(Safely) Removing Rust from Chassis
I’m a big fan of vinegar as well. It works wonders to leave a rusty piece of metal soaking in vinegar for a few days. Re...jrblasde — 09:59 PM
(Safely) Removing Rust from Chassis
I've had good luck using a wad of paper towel, soaked in vinegar, on thick crusty rust that the usual rust removers won'...Arran — 09:39 PM
NRI 68 tube tester for newer tubes
Those two are not on the list either. I believe these tubes were introduced after the tester was made.Tennangler — 08:38 PM
Cool Find/Looking for info
I know this is a very old post, but the question still remains. They DO NOT MATCH up. My 144 Philco has 4 bands and if...Villager61 — 07:52 PM
Philco 60 restoration
Remembered that I wanted to clean the tuning cap. At the same time the rust spots are better accessible without the cap...morzh — 07:41 PM
(Safely) Removing Rust from Chassis
Thank you for the details. I didn’t see anything about a rag saturated with water on the packaging, but I saw that same ...jrblasde — 07:09 PM
1930s Stewart-Warner Tombstone Radio need help identifying model number
Thanks for the help, I was able to make an old wire grommet that was about the same size as the original rubber tire wor...captainclock1988 — 02:33 PM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration