1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
1930s Stewart-Warner Tombstone Radio need help identifying model number
captainclock1988
Senior Member
****
Posts: 315
Threads: 32
Joined: Dec 2019
City: Elkhart State, Province, Country: Indiana
#17

12-29-2024, 12:09 PM
could a bad oscillator tube cause the problems I'm having? I'm asking because I know the original Rectifier tube (an 80)  was shorted so it wasn't allowing the radio to power up at all, so I wonder if the oscillator tube is bad as well? I hadn't had a chance to test every single tube inside the radio yet.
Find
« Next Oldest | Next Newest »


Messages In This Thread
462ron - by 462ron - 12-29-2024, 09:09 AM
RE: 1930s Stewart-Warner Tombstone Radio need help identifying model number - by captainclock1988 - 12-29-2024, 12:09 PM
462ron - by 462ron - 12-29-2024, 04:04 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
TDS320 scope
Well, it is not a necessity. I was given it from my work; they did not know what to do with it. I though at the time, i...morzh — 10:15 PM
Jeff Dunham unboxing an unopened Philco Predictata
nice...morzh — 09:45 PM
Can't figure out where this wire goes on Philco 37-640
Like I said. This is the filament. All wires for the filaments in all the tubes, except the rectifier one, are parallell...morzh — 09:43 PM
Jeff Dunham unboxing an unopened Philco Predictata
but how in the world was there a NOS Predicta found after all those years! You'd be surprised what is stuck up in at...Eliot Ness — 08:08 PM
Can't figure out where this wire goes on Philco 37-640
Thanks so much for the reply.  I will look at it again but now I noticed that the original wire(about 4 inches long)woul...georgetownjohn — 06:08 PM
The list of my radio & TV collection!
I continue showing videos on the history of radio broadcasting from the series "To the 100th anniversary of radio b...RadioSvit — 03:43 PM
Can't figure out where this wire goes on Philco 37-640
Pin #2 is a one of the two filament pins. It could be the one that goes to GND (chassis). It will also go to the rest of...morzh — 03:30 PM
Philco 49-607 inop
A photo would help. Rod, of course, all the plugs I order for the portables are non-pol. Not just that, but also...morzh — 03:17 PM
Can't figure out where this wire goes on Philco 37-640
Happy New Year Phorum Members! I am stumped on my Philco 37-640. I have a wire in the tuner/rf section that I cannot det...georgetownjohn — 02:59 PM
Philco 49-607 inop
The photo is exactly what mine looks like. See the small hole on the bottom right side of the cabinet? What is that for?Tennangler — 12:39 PM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)