1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco 60 Wave Trap
RossH
Junior Member
**
Posts: 18
Threads: 2
Joined: Dec 2020
City: Muhlenberg County State, Province, Country: KY
#2

12-31-2024, 01:25 PM
I've left them out and tried the radio, left them and tried the radio. No difference. Having said that, I'm wont to leave them provided the coil is still good. I hope that was vague enough.
When you unsolder what has been soldered before the unsoldering, the unsoldering of the soldered is what will be.
Find
« Next Oldest | Next Newest »


Messages In This Thread
Philco 60 Wave Trap - by dconant - 12-30-2024, 02:37 PM
RE: Philco 60 Wave Trap - by RossH - 12-31-2024, 01:25 PM
RE: Philco 60 Wave Trap - by morzh - 12-31-2024, 04:13 PM
RE: Philco 60 Wave Trap - by dconant - 12-31-2024, 05:01 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 38-690 input jack
Might need something like this?  David — 07:43 PM
Philco 38-690 input jack
I am just using a portable cd player,and a mono cord.supertech — 07:11 PM
Philco 38-690 input jack
How did you combine the 2 channels of the CD player into the input jack? DavidDavid — 07:02 PM
Philco Candohm Repair
Hello, I have a 91 waiting it's turn. It's  candohm has a bad spot. I have seen where some people say it is not a good i...dconant — 07:00 PM
Philco 38-690 input jack
got an input jack put in the 38-690. Sounds very good with a cd player but not full volume. Should a preamp of some sort...supertech — 02:28 PM
Philco 49-607 inop
Mrfixr55, The power cord goes out the hole in the back panel so hole on the side must be the external antenna access as...Tennangler — 02:27 PM
Philco in wine ad campaign
NostalgiaRadioTime — 12:41 PM
Philco in wine ad campaign
Country music singer Martina McBride has a new signature wine ? called Luna and Finn, named after her pets. This photo w...NostalgiaRadioTime — 12:40 PM
Philco IF Coil
Dunno. I tried to have all wires more or less where they originally belonged, and have shields installed with the one gr...morzh — 11:29 AM
Philco IF Coil
Yep Mike I was puzzled. I did work with a dab of solder on the tip with flux. No go so I scrapped what little wire I had...dconant — 10:49 AM

[-]
Who's Online
There are currently 2896 online users. [Complete List]
» 1 Member(s) | 2895 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration