Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco IF Coil
#3

Yep Mike I was puzzled. I did work with a dab of solder on the tip with flux. No go so I scrapped what little wire I had to work with and that did the job. I didn't want to mess around too much and wind up with a broken coil wire. Anyway it is back in the radio and playing nicely. Thanks for the info. Did have to mess with one of the wires to get the radio to stop squealing. Little bit touchy in that area. On your 60 I just can't imagine how you managed to get all those wires back without having squealing issues.


Messages In This Thread
Philco IF Coil - by dconant - 01-06-2025, 09:39 AM
RE: Philco IF Coil - by morzh - 01-06-2025, 10:01 AM
RE: Philco IF Coil - by dconant - 01-06-2025, 10:49 AM
RE: Philco IF Coil - by morzh - 01-06-2025, 11:29 AM
RE: Philco IF Coil - by Chas - 01-06-2025, 10:09 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
HiFi (Chifi) tube amp build - but my own design.
Tim, I have some bakelite sockets in my work shop that I can dig up. I believe quite a few are NOS. I will take photo...RodB — 10:03 PM
Philco 610B oscillator wiring
> The cathode as noted is wired directly to the ground side of the heater filament for that tube, not to the #17 and ...Radioroslyn — 08:12 PM
HiFi (Chifi) tube amp build - but my own design.
Tim; I noticed your post a little late, but I would take one of the junk sockets and try to break a chunk out of it wi...Arran — 08:07 PM
Need to purchase some accessories for restoration of my Old Philco Radio
Here is a list of resources found in our online library that you might find useful. Mike's Gobs of Knobs email addres...klondike98 — 01:46 PM
First Radio restoration
Hi Tubeman, Welcome to the Philco Phorum.  Phamily Phriendly Pfun with Phine Pholks Phull of Philco Phacts. (See a p...MrFixr55 — 12:33 PM
First Radio restoration
You could post in the WANTED ADs section here on the Phorum and see if anyone has an RF generator that they want to sell...klondike98 — 11:55 AM
Zenith H725
Good ideas, thank you Arrange and Rich. I have the adhesive aluminum foil already and can try that immediately. More ...EdHolland — 10:18 AM
Graphics for majestic 1050 dial glass.
Murf; I found this thread on the ARF, the first photo has a pretty good view of the dial glass. Regards ArranArran — 01:12 AM
Zenith H725
hello Ed, how about that speacial tape used for ducting it's like foil or how about thin piece of aluminum roof flash...radiorich — 12:19 AM
Zenith H725
Ed; One material that I have seen, but never tried for this was material for making exhaust gaskets, it's similar to ...Arran — 11:42 PM

[-]
Who's Online
There are currently 1667 online users. [Complete List]
» 1 Member(s) | 1666 Guest(s)
Avatar

>