Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Need help in identifying model
#5

just to clarify, when you say the throttle condensor is #17, you're referring to the schematics in this thread and the part labeled #17, correct? Is the throttle condensor a different name for the trimming cap that you mentioned? 

Sorry for the ignorant question. Radio repair is new to me.

I did watch last night the three videos of "Buzz" restoring an old 84. From watching that video I saw that there are two adjusting screws on the back of the chassis that can be used to do the alignment. I'll research that topic and look at doing that. On that video, there was also an antenna adjusting screw near the tuner knob. I'll pull the chassis out and see if my unit has that adjusting screw too, although I'm not sure what it means to adjust the antenna, so I'll have to research that too if my chassis has that piece.

Thanks again.
Dale


Messages In This Thread
Need help in identifying model - by dapanattoni - 01-09-2025, 04:40 PM
RE: Need help in identifying model - by morzh - 01-09-2025, 07:17 PM
RE: Need help in identifying model - by dapanattoni - 01-10-2025, 02:31 PM
RE: Need help in identifying model - by morzh - 01-10-2025, 04:09 PM
RE: Need help in identifying model - by GarySP - 01-10-2025, 11:14 PM
RE: Need help in identifying model - by radiorich - 01-11-2025, 01:33 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 39-7C Restore
A little more work today. I got the first IF transformer back together after replacing the wiring going to the 78 tube ...klondike98 — 12:06 AM
Two small radios from France. Restoration and review.
And here they are, the French beauties ready: In summary, the suspicion that radio transmits the national cha...Vlad95 — 10:46 PM
Two small radios from France. Restoration and review.
One is ready for washing, the other for painting: ATTENTION Faint-hearted and heart patients, please d...Vlad95 — 10:36 PM
Two small radios from France. Restoration and review.
Range Switch Block: I thought that mica capacitors of this type died out in the 30s, but no, they just moved ...Vlad95 — 10:29 PM
Two small radios from France. Restoration and review.
Chassis bottom view: Again, like twins, especially in the range switch part. Front panels: And...Vlad95 — 10:25 PM
Two small radios from France. Restoration and review.
Chassis removed, front view: Chassis rear view: It will be enough for the first device to prescribe a bath. Bu...Vlad95 — 10:11 PM
Two small radios from France. Restoration and review.
France Peculiarities of national character. Excelsior-52 threw me off track. It was too far outside my established...Vlad95 — 10:06 PM
Philco 16b no shortwave reception
First let thank everyone who helped ID this radio a few weeks ago! I have replaced all the capacitors and was able to r...Ken D. — 08:07 PM
Philco model 38 code 121 not receiving signal.
Ah yes, the Philco "Green Death" strikes again, someone suspected that cellulose nitrate based insulation migh...Arran — 06:23 PM
Philco model 38 code 121 not receiving signal.
Not sure if it matters much, but measure where the winding sits on the tube and try to rewind as close as possible. Tak...GarySP — 05:45 PM

[-]
Who's Online
There are currently no members online.

>