Philco 46-480 Electronic Restoration
Posts: 256
Threads: 15
Joined: Jan 2024
City: Tulsa
State, Province, Country: Oklahoma
I should also make two more comments. First, the diameter of this PCB is 1.45", to match the diameter of the multi-section capacitor I am replacing. The QC connectors I am using for the twist lock connectors are positioned exactly where they will pass through the cutouts in the chassis. And second, all clearances and creepage distances are in excess ofthe 3mm design constraint. Hence why there are no cutouts or notches in the PCB. I believe the smallest distance measured was 5 mm.
Joseph
Philco 46-480
Philco 49-906
Messages In This Thread
RE: Philco 46-480 Electronic Restoration - by jrblasde - 01-11-2025, 06:30 PM
Users browsing this thread: 3 Guest(s)
|
Recent Posts
|
HiFi (Chifi) tube amp build - but my own design.
|
Tim,
I have some bakelite sockets in my work shop that I can dig up. I believe quite a few are NOS. I will take photo...RodB — 10:03 PM |
Philco 610B oscillator wiring
|
> The cathode as noted is wired directly to the ground side of the heater filament for that tube, not to the #17 and ...Radioroslyn — 08:12 PM |
HiFi (Chifi) tube amp build - but my own design.
|
Tim;
I noticed your post a little late, but I would take one of the junk sockets and try to break a chunk out of it wi...Arran — 08:07 PM |
Need to purchase some accessories for restoration of my Old Philco Radio
|
Here is a list of resources found in our online library that you might find useful. Mike's Gobs of Knobs email addres...klondike98 — 01:46 PM |
First Radio restoration
|
Hi Tubeman,
Welcome to the Philco Phorum. Phamily Phriendly Pfun with Phine Pholks Phull of Philco Phacts. (See a p...MrFixr55 — 12:33 PM |
First Radio restoration
|
You could post in the WANTED ADs section here on the Phorum and see if anyone has an RF generator that they want to sell...klondike98 — 11:55 AM |
Zenith H725
|
Good ideas, thank you Arrange and Rich. I have the adhesive aluminum foil already and can try that immediately.
More ...EdHolland — 10:18 AM |
Graphics for majestic 1050 dial glass.
|
Murf;
I found this thread on the ARF, the first photo has a pretty good view of the dial glass.
Regards
ArranArran — 01:12 AM |
Zenith H725
|
hello Ed,
how about that speacial tape used for ducting it's like foil or how about thin piece of
aluminum roof flash...radiorich — 12:19 AM |
Zenith H725
|
Ed;
One material that I have seen, but never tried for this was material for making exhaust gaskets, it's similar to ...Arran — 11:42 PM |
Who's Online
|
There are currently 1666 online users. [Complete List] » 1 Member(s) | 1665 Guest(s)
|
|
|

|