Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 41 280 Floor radio-new project.
#2

Hello willits18,
First of all I wanted to say welcome to our little forum.
over all that set does not look in to bad of shape First thing I would do is get good schematic diagram of that set and myself I like to take a lot photos and notes along with marking wires and parts .

Sincerely Richard


Messages In This Thread
RE: Philco 41 280 Floor radio-new project. - by radiorich - 7 hours ago



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 41 280 Floor radio-new project.
Rough but restorable. The rubber wiring seems to be in OK shape; the white wires often stay pliable and do not need to ...morzh — 11:03 PM
Philco 41 280 Floor radio-new project.
Hello willits18, First of all I wanted to say welcome to our little forum. over all that set does not look in to bad o...radiorich — 10:48 PM
Philco 41 280 Floor radio-new project.
Just picked this up locally. No power cord. When I tested the tubes I think I know why. 3 bad tubes, 2 shorted, and 1 ba...willits18 — 10:08 PM
Model 41-280 5 dials
for the dial you can try Radio Daze.  willits18 — 09:58 PM
Model 41-280 5 dials
For the dial you can try Radio Daze willits18 — 09:57 PM
[split] New member...
See if this helps. This is Philco Auto Tuning service bulletin. I think this is same as yours. I used it on my 37-...morzh — 08:14 PM
[split] New member...
In my shafts (yes they are a bit differnt but the idea is the same, three balls as planetary gear and a small ball and a...morzh — 08:00 PM
42-345 Resistors
Thank you to everyone who has replied. The two mystery objects are either mini cannoli or oscillators. I'm not quite su...proftrussell — 07:57 PM
[split] New member...
Btw, the thread you provided me with the service hint & tip on refurbishing this tuning shaft was written by "...HowardWoodard — 07:55 PM
[split] New member...
Yes the three ball bearings should go in the holes. The spring with teh cap should go first, then the balls (with some l...morzh — 07:21 PM

[-]
Who's Online
There are currently no members online.

>