Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Transitone 46-200 parts list?
#1

I picked up this Philco 46-200 at an auction recently and once I opened it, it's a real mess. There was a lytic laying loose on top of the chassis with a pair of wires running around the end of the chassis and connected underneath. Another large lytic strapped with a tie underneath and using the same all green wires to connect it. Neither lytic is marked so I have no idea what's what. There are numerous wires that have been replaced underneath, all with red plastic coated wire. To top it off the speaker has been replaced with a tiny 3" one that doesn't fit and is held in place with a metal strip soldered to the chassis.

OK, all that being said, I guess I'm a glutton for punishment but I'm going to give it a try. I have decent copies of the schematic but what would really help is a parts list. Any chance someone would have one or know where I could find one?

Thanks,
Larry


Messages In This Thread
Transitone 46-200 parts list? - by rocketeer - 08-12-2011, 09:05 PM
Re: Transitone 46-200 parts list? - by rocketeer - 08-12-2011, 10:42 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Rusty Tuning Condenser
Give the tuner a good wash in Dawn and hot water. Then set tuner in a plastic container and cover with vinegar let soak ...David — 12:53 PM
Rusty Tuning Condenser
If you have rust between the vanes, I wonder how you get the NJ in between, and how you then wipe it off.morzh — 12:02 PM
Philco 60 Squealing
If the noise is still there, the OPT might just be OK. Or so we hope.morzh — 12:01 PM
Philco 60 Squealing
You would probably be replacing the OPT.RodB — 10:54 AM
Philco 60 Squealing
I have been playing the radio for a while now and doing well. Turned it on today and all I got was a whole lot of noise....dconant — 09:39 AM
Rusty Tuning Condenser
Thanks guys. I think I'll give the Naval Jelly a try since I can better control where it goes.dconant — 09:23 AM
Philco Model 80 Transformer resistance
Just forget this number, it is useless anyway. Simply proceed with your project.morzh — 10:08 PM
Philco Model 80 Transformer resistance
My $0.02 is that it is a misprint. I tried to look up the value for the similar 84 and 37-84, and ther is no resistance...MrFixr55 — 09:51 PM
Philco Model 80 Transformer resistance
Thanks for the quick reply! Hmm...well that's good, so what am I seeing that's 1042 ohms on the schematic for the pow...Mike L — 08:46 PM
Philco Model 80 Transformer resistance
The DC resistance of the primary is 8 to 9 Ohm.morzh — 07:54 PM

[-]
Who's Online
There are currently 3599 online users. [Complete List]
» 2 Member(s) | 3597 Guest(s)
AvatarAvatar

>