1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Atwater Kent 708 Flexible Resistor Identification Needed
Tonym4704
Junior Member
**
Posts: 12
Threads: 6
Joined: Jun 2024
City: Shirley State, Province, Country: MA
#3

Yesterday, 07:37 PM
Hello,
That diagram in Rider's is a little different from the setup that I have. Note that the R11 resistor connects to ground and the one in my radio connects to the choke. R1 and R9 look correct though.
Find
« Next Oldest | Next Newest »


Messages In This Thread
RE: Atwater Kent 708 Flexible Resistor Identification Needed - by Tonym4704 - Yesterday, 07:37 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco model 38 code 121 not receiving signal.
Well I found it and it's not good. The primary of the antenna coil is shot.The famous (or infamous) Philco coil rot got ...Stormlord5500 — 11:58 AM
Atwater Kent 708 Flexible Resistor Identification Needed
Tony Could you possibly trace the flexes to where they go in your chassis? Should'nt be too hard.morzh — 09:23 PM
Atwater Kent 708 Flexible Resistor Identification Needed
None of the diagrams that are shown online are the same as what I have drawn. It is my setup with the two resistors conn...Tonym4704 — 08:47 PM
Atwater Kent 708 Flexible Resistor Identification Needed
morzh You are right. Scematic 808 is corresponded requered. On this case Purple - R11A 160 ohms Red - R11B 160 ohms Bu...Vlad95 — 08:07 PM
Atwater Kent 708 Flexible Resistor Identification Needed
Have you looked in here? And in here. 708, 808 and 808A are very similar.morzh — 07:43 PM
Atwater Kent 708 Flexible Resistor Identification Needed
Hello, That diagram in Rider's is a little different from the setup that I have. Note that the R11 resistor connects to...Tonym4704 — 07:37 PM
Atwater Kent 708 Flexible Resistor Identification Needed
According scematic in "Rider volume" #4 page 17 Green - R1 425 ohms (corresponded your measurement) Blue -...Vlad95 — 07:10 PM
Atwater Kent 708 Flexible Resistor Identification Needed
Hello Everyone, I am in the process of rebuilding the sub-chassis in an Atwater Kent 708 radio serial number 4796904 an...Tonym4704 — 05:14 PM
Zenith H725
Yes this set has a neon pilot lamp, type NE51.EdHolland — 08:04 AM
Philco model 40-100
Hi Marion, I don't know; I never researched it. I would think that function would be really annoying, but it would be...MrFixr55 — 07:59 AM

[-]
Who's Online
There are currently 2132 online users. [Complete List]
» 2 Member(s) | 2130 Guest(s)
AvatarAvatar

>
  1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)