1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Atwater Kent 708 Flexible Resistor Identification Needed
Vlad95
Junior Member
**
Posts: 8
Threads: 1
Joined: Apr 2025
City: SPRUCE GROVE State, Province, Country: Alberta
#5

Yesterday, 08:07 PM
morzh
You are right. Scematic 808 is corresponded requered.
On this case
Purple - R11A 160 ohms
Red - R11B 160 ohms
But red according scematic connected from chok to 2nd I.F.
On picture look lile mistake that it going to ground istead  2nd I.F.

808 scematic present in "Rider volume" #5 page 42
(This post was last modified: Yesterday, 08:09 PM by Vlad95.)
Website Find
« Next Oldest | Next Newest »


Messages In This Thread
RE: Atwater Kent 708 Flexible Resistor Identification Needed - by Vlad95 - Yesterday, 08:07 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 16b no shortwave reception
First let thank everyone who helped ID this radio a few weeks ago! I have replaced all the capacitors and was able to r...Ken D. — 08:07 PM
Philco model 38 code 121 not receiving signal.
Ah yes, the Philco "Green Death" strikes again, someone suspected that cellulose nitrate based insulation migh...Arran — 06:23 PM
Philco model 38 code 121 not receiving signal.
Not sure if it matters much, but measure where the winding sits on the tube and try to rewind as close as possible. Tak...GarySP — 05:45 PM
Superior 450 schematic
I need a schematic for this tube tester.daveone23 — 05:00 PM
Philco model 38 code 121 not receiving signal.
>> Yes. Ball up in a corner and cry very deeply? It's a good start :lol: Then try to get off the outer shell...morzh — 02:54 PM
Philco model 38 code 121 not receiving signal.
Yes. Ball up in a corner and cry very deeply? :P  :lol: I've never rewound a coil so first time for everything I guess....Stormlord5500 — 01:58 PM
Philco model 38 code 121 not receiving signal.
Well, you know what to do then.morzh — 01:27 PM
Philco model 38 code 121 not receiving signal.
Well I found it and it's not good. The primary of the antenna coil is shot.The famous (or infamous) Philco coil rot got ...Stormlord5500 — 11:58 AM
Atwater Kent 708 Flexible Resistor Identification Needed
Tony Could you possibly trace the flexes to where they go in your chassis? Should'nt be too hard.morzh — 09:23 PM
Atwater Kent 708 Flexible Resistor Identification Needed
None of the diagrams that are shown online are the same as what I have drawn. It is my setup with the two resistors conn...Tonym4704 — 08:47 PM

[-]
Who's Online
There are currently 831 online users. [Complete List]
» 2 Member(s) | 829 Guest(s)
AvatarAvatar

>
  1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)