philco 42-400 volume wheel

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

philco 42-400 volume wheel

btoher
Junior Member

Posts: 20
Threads: 4
Joined: Aug 2010
City: Little Falls / N.Y

09-16-2011, 06:27 AM

Ron : That may work because as I recall it is only a couple teeth at the end. I will have to wait a while to check it out though. After I posted the question I fell off my roof about ten feet high and broke my shoulder .I will be ok. But will take a break from fixing things to heal . This was a radio my wife bought 25 years ago before I had any radio interest . Once I got to it and had it running I was very happy with it .It is a big thing and sounds goods .Not the best looking of the bunch but a work horse . Thanks for tip and have a good one!!!

bill

Find

« Next Oldest | Next Newest »

Messages In This Thread

philco 42-400 volume wheel - by btoher - 08-25-2011, 06:46 AM

Re: philco 42-400 volume wheel - by Ron Ramirez - 09-14-2011, 08:55 PM

Re: philco 42-400 volume wheel - by btoher - 09-16-2011, 06:27 AM

Re: philco 42-400 volume wheel - by w4rtc - 09-16-2011, 10:31 AM

Re: philco 42-400 volume wheel - by btoher - 09-20-2011, 07:52 PM

Re: philco 42-400 volume wheel - by Ron Ramirez - 09-20-2011, 09:07 PM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone, As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic. This radio had a 8" Zenith speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM

Who's Online

There are currently 4825 online users. [Complete List]
» 1 Member(s) | 4824 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me