Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

A Marconi model 86
#23

Thanks 
 I also have some arthritis in my hands, and it is getting a little harder to lift these radio cabinets
on and off so I can work on them. I find it very enjoyable to make the radios look like they came out of the factory.

  Sometimes I do change the toned lacquer a little, but many of the old radios were very dark and I lighten them up a bit.
     I am glad that the guys on any of the forums like the cabinets.
 I do get a lot of comments , so I must be doing something right.
Dan in Calgary

   Living in Calgary Alberta


Messages In This Thread
A Marconi model 86 - by Dan Walker - 02-21-2025, 12:07 PM
RE: A Marconi model 86 - by jrblasde - 02-21-2025, 12:19 PM
RE: A Marconi model 86 - by morzh - 02-21-2025, 12:43 PM
RE: A Marconi model 86 - by Paul Philco322 - 02-21-2025, 02:49 PM
RE: A Marconi model 86 - by morzh - 02-21-2025, 02:51 PM
RE: A Marconi model 86 - by Arran - 02-21-2025, 05:09 PM
RE: A Marconi model 86 - by Dan Walker - 02-21-2025, 07:01 PM
RE: A Marconi model 86 - by morzh - 02-21-2025, 07:15 PM
RE: A Marconi model 86 - by Arran - 02-21-2025, 07:27 PM
RE: A Marconi model 86 - by GarySP - 02-21-2025, 07:32 PM
RE: A Marconi model 86 - by morzh - 02-21-2025, 07:47 PM
RE: A Marconi model 86 - by Paul Philco322 - 02-21-2025, 08:12 PM
RE: A Marconi model 86 - by morzh - 02-21-2025, 08:28 PM
RE: A Marconi model 86 - by MrFixr55 - 03-24-2025, 07:32 AM
RE: A Marconi model 86 - by Dan Walker - 03-24-2025, 09:56 AM
RE: A Marconi model 86 - by Dan Walker - 05-21-2025, 10:48 AM
RE: A Marconi model 86 - by Dan Walker - 06-10-2025, 12:18 AM
RE: A Marconi model 86 - by radiorich - 06-10-2025, 08:13 AM
RE: A Marconi model 86 - by Dan Walker - 06-10-2025, 09:19 AM
RE: A Marconi model 86 - by Paul Philco322 - 06-10-2025, 09:40 AM
RE: A Marconi model 86 - by Dan Walker - 06-10-2025, 09:50 AM
RE: A Marconi model 86 - by RodB - 06-10-2025, 09:51 AM
RE: A Marconi model 86 - by Dan Walker - 06-10-2025, 10:01 AM
RE: A Marconi model 86 - by RodB - 06-10-2025, 12:22 PM
RE: A Marconi model 86 - by Arran - 06-10-2025, 02:16 PM
RE: A Marconi model 86 - by Dan Walker - 06-10-2025, 08:10 PM
RE: A Marconi model 86 - by radiorich - 06-10-2025, 08:50 PM
RE: A Marconi model 86 - by Dan Walker - 06-10-2025, 10:48 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 42-345 Restoration/Repair
In some cases the old paper caps can be replaced with ceramic caps, with values such as .001 uf, .005 uf, .01 uf, and ma...Arran — 06:50 PM
1949 Motorola 5A9M
Vlad; I would tend to agree, I only suggested the loop antenna connections since he was already looking at the end of...Arran — 06:18 PM
Philco 42-345 Restoration/Repair
Rod thank you for helping to understand the paper caps and offering the bumblebee caps. I have already ordered film caps...osanders0311 — 03:55 PM
1949 Motorola 5A9M
Bob, this is the wrong sequence to look for problems and setup circuits. Always start checking the signal path from the...Vlad95 — 12:19 PM
Philco J1720 stereo and record player with reverb
The above link takes you to the Delaware Valley Historic Radio club. They are not too far from you and may have sugg...klondike98 — 11:49 AM
Tucker Movie Prop car
Richard: Did you ever check with your friend? About once a year I try to verify if Mr Rhoades really worked on the r...WrenchMonkey — 09:22 AM
Philco J1720 stereo and record player with reverb
>>when turning the knobs This is very broad. There are knobs for tuning and knobs for volume, and possibly f...morzh — 07:36 AM
1949 Motorola 5A9M
Thx Arran, I will check the antenna connections. Right now the loop is alligator clip connected to the chassis since you...klondike98 — 03:58 AM
1949 Motorola 5A9M
Bob; I was just thinking that maybe the 1R5 tube doesn't like being operated at 1.2 volts on the filament, though you...Arran — 12:56 AM
Philco J1720 stereo and record player with reverb
So I just purchased a Philco J1720 stereo and record player. That has some static when turning the knobs. Wanted to see ...PhilcoJ1720 — 12:26 AM

[-]
Who's Online
There are currently 1191 online users. [Complete List]
» 2 Member(s) | 1189 Guest(s)
AvatarAvatar

>