06-20-2025, 10:35 PM
Finally pulled the chassis. Doesn't look very pretty underneath.
No screws holding the chassis in place, no screws holding the chassis bottom plate in place and the tube shield has a tube label for a model 48. The model 48 used the same cabinet as the 52C
The remaining filter can appears to still be wired up. Will investigate further and correct if necessary. The 2.5 VAC filament transformer is located under the chassis and not even where the original was located. Replacement filters are taped together where the original transformer was.
Does not appear the paper caps were replaced.
I will troubleshoot this mess to get it working again.
No screws holding the chassis in place, no screws holding the chassis bottom plate in place and the tube shield has a tube label for a model 48. The model 48 used the same cabinet as the 52C
The remaining filter can appears to still be wired up. Will investigate further and correct if necessary. The 2.5 VAC filament transformer is located under the chassis and not even where the original was located. Replacement filters are taped together where the original transformer was.
Does not appear the paper caps were replaced.
I will troubleshoot this mess to get it working again.
![[-]](https://philcoradio.com/phorum/images/bootbb/collapse.png "[-]")
