07-08-2025, 09:56 PM
Hello Guys,
I am working on a special project for a custom car The radio started life as 1946 ford zenith car radio but being size and new electric wipers installed the original radio had to be cut off making it like 4 inches deep So we decided to install a bluetooth amp .
So what need to do is to change the control from 500k to 1k linear control
Here is the photo of the control which is made by CTS and I did order Few CTS Pots from mouser but none of them have the right shaft or able dual control.
Anyway I could use your guys help building this control even if I need to get Potentiometer from different company like Alps I need the same set up two Potentiometer plus on/off switch and I have both the brass control and that later steel shaft one .
Sincerely Richard
I am working on a special project for a custom car The radio started life as 1946 ford zenith car radio but being size and new electric wipers installed the original radio had to be cut off making it like 4 inches deep So we decided to install a bluetooth amp .
So what need to do is to change the control from 500k to 1k linear control
Here is the photo of the control which is made by CTS and I did order Few CTS Pots from mouser but none of them have the right shaft or able dual control.
Anyway I could use your guys help building this control even if I need to get Potentiometer from different company like Alps I need the same set up two Potentiometer plus on/off switch and I have both the brass control and that later steel shaft one .
Sincerely Richard
![[-]](https://philcoradio.com/phorum/images/bootbb/collapse.png "[-]")
