Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12, 2025) x

Thread Closed

Jackson 648a how test 264c?
#3

And send a few to me. A good replacement for WD11s. Dunno how popular 264s are but 864s are getting scarce. I bought 2 NOS Hytron JAN VT24s about 10 years ago from someone on eBay, I think I paid $10 each.

Radiomuseum states that this tube is a new and improved, and rebased WD11 (ANYTHING is an improvement over a WD11).


Following is from RadioMuseum:

Identical to 864 = CV2675 = VT-24 = SE-3864A = 264 = CX864 = 464 = ER864 = TS864 = T-864
Similar Tubes
Normally replaceable-slightly different:
38064 ; FR-300 ; WX12
Predecessor Tubes WD11 UX864
Base UX-Base (4 Pins (2 thick, USA 1924, UX) (Codex=Bo)
Was used by Radio/TV-reception etc.
Filament Vf 1.1 Volts / If 0.25 Ampere / Direct / Specified voltage AC/DC
Description
Low-microphonic rebased and improved WD11; mu 8.2, Gm 0.65mS.

Sturdy non-microphonic tube for aircraft communication. Airplane vibrations caused noise in the receiver using normal tubes. Three of these tubes used in the RCA 4088 condenser microphone. It was classified for industrial use but was released for general distribution in April 1932.

"Do Justly, love Mercy and walk humbly with your God"- Micah 6:8
"Let us begin to do good"- St. Francis

Best Regards, 

MrFixr55


Messages In This Thread
Jackson 648a how test 264c? - by mancave - 10-04-2025, 08:04 AM
RE: Jackson 648a how test 264c? - by Chas - 10-04-2025, 05:02 PM
RE: Jackson 648a how test 264c? - by MrFixr55 - 10-04-2025, 11:47 PM
RE: Jackson 648a how test 264c? - by mancave - 10-05-2025, 02:21 PM
RE: Jackson 648a how test 264c? - by DaleHCook - 10-06-2025, 09:06 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 71 Code 125
Technically, that's C-. B- is chassis ground. The resistor between chassis ground and the HV center tap makes the HV c...MrFixr55 — 11:24 PM
54C Cabinet Refinish
hello Roy, I’d follow Arran’s suggestion and use automotive gasket material, which I keep around for situations like th...radiorich — 10:22 PM
Philco 71 Code 125
This might be one of those cases where it's a ground to an AC voltage and B- to DC.RodB — 08:22 PM
Philco 71 Code 125
Really Rod? I know you would not steer me wrong but AI say this is a short circuit? What if I moved the 6 volt center ta...dconant — 06:40 PM
54C Cabinet Refinish
Roy; Personally I would have left the asbestos alone if it were my set, but you can find a modern substitute that som...Arran — 04:51 PM
Philco 71 Code 125
Looks like that might be the B- buss, so that would be correct.RodB — 01:32 PM
Philco 71 Code 125
I noticed on the code 121 schematic the center tap for the 6 volt winding and hv winding are tied together. Is this corr...dconant — 12:16 PM
Philco 45-6365 Universal IFT Instruction Manual
The Philco Parts Catalog for 1942 shows it as usable for 175 kHz, 260 kHz, and 465 kHz. The instructions will show how t...DaleHCook — 11:19 AM
Stromberg Carlson 1500 Squeal
Hello Rob, I agree with you—I have one here at my house that I need to check out. It’s way over-engineered just to make...radiorich — 11:05 AM
My Atwater Kent 84
Well getting around to restoring my AK84. Mike was a big part in me being able to snatch this one a few years ago. I won...462ron — 10:57 AM

[-]
Who's Online
There are currently 1785 online users. [Complete List]
» 1 Member(s) | 1784 Guest(s)
Avatar

>