40-180 buttons needed

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

40-180 buttons needed

OzRadio
Junior Member

Posts: 17
Threads: 9
Joined: Aug 2006

08-09-2006, 07:53 AM

Hi all,
I'm working (slowly and painfully) on my first radio repair. I need a set of the channel pre-set buttons for a Philco 40-180. Are these readily available? If so, where would I look? Also, what is that big muffler-looking piece that sets at the bottom of the console?
Thanks,
Ryan

Website Find

« Next Oldest | Next Newest »

Messages In This Thread

40-180 buttons needed - by OzRadio - 08-09-2006, 07:53 AM

[No subject] - by Sean - 08-09-2006, 08:08 AM

[No subject] - by Carl Travis - 08-09-2006, 02:05 PM

[No subject] - by OzRadio - 08-10-2006, 07:28 PM

[No subject] - by gary rabbitt - 09-28-2006, 07:01 PM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

Who's Online

There are currently 2588 online users. [Complete List]
» 2 Member(s) | 2586 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me