[Garagejunky]

Thank you all for the replies !! I did figure it out after all. The Idler arm that slides back and forth and up and down, was not going up and down. The stops were just butting and stopping the arm from going into the third position. It was the old grease holding it as if it were pressed on. I used a lighter, heated it up just enough to get the piece off and cleaned it up with alcohol. Greased it up and it’s working great. I am along way from completing this project. I still have to recap the radio which is working fine with the old paper caps but From all i’ve read they could be leaking ? I have never recapped a radio but I think I can get it all done. I’m sure I’ll have some additional question's. Thank you all again. Much appreciated!
.