[Joe Rossi]

I finished recapping and re-resitoring my 49-602.  It initially fired up fine, but I needed to replace the 4PDT slide switch for battery/AC selection.  Surgery went well, but when I plugged it in to the Variac I got nothing.  No 120VAC.  I checked the output of the Variac and it measures 120VAC at the output.  I checked the continuity of the NEW line-cord, it is OK. I checked each individual connection to the new 4PDT switch to make sure the hook-up is correct.  I triple checked it.  It is correct and functions correctly measured with the DVM. The tubes check good. I replaced the selenium rectifier with a 1N5408 (overkill, I know) and compensating resistor. I checked the sets power switch (twice) and it works as designed.  I checked every solder joint.  No cold joints or loose or broken wires.  There are no open circuits.  Ay-yi-yi!  I have attached the schematic for perusal.  Any thoughts?  Thanks folks!  Joe