1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
philco 42-400 volume wheel
btoher
Junior Member
**
Posts: 20
Threads: 4
Joined: Aug 2010
City: Little Falls / N.Y
#5

09-20-2011, 07:52 PM
Joe: That is a good suggestion also! I didn't think of that .I will try to do what Ron suggested first and see what happens . Still got a ways to go with the shoulder yet.
I stopped short of looking for an old chasis because I thought 90 percent of the parts would go unused.But fishing for the wheel only is smarter . Thanks for the idea!
Glad you did not break anything ! I guess we can't claim to be good climbers . I always do things safe when it comes to electrical work .And never take any chances .Should have taken my own advice when roofing . But though I was up high enough to get hurt badly .
That might have been true if I landed on my feet ! Thanks again and have a good one!

bill
Find
« Next Oldest | Next Newest »


Messages In This Thread
philco 42-400 volume wheel - by btoher - 08-25-2011, 06:46 AM
Re: philco 42-400 volume wheel - by Ron Ramirez - 09-14-2011, 08:55 PM
Re: philco 42-400 volume wheel - by btoher - 09-16-2011, 06:27 AM
Re: philco 42-400 volume wheel - by w4rtc - 09-16-2011, 10:31 AM
Re: philco 42-400 volume wheel - by btoher - 09-20-2011, 07:52 PM
Re: philco 42-400 volume wheel - by Ron Ramirez - 09-20-2011, 09:07 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM

[-]
Who's Online
There are currently 4928 online users. [Complete List]
» 1 Member(s) | 4927 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration