[HarryWeatherford]

Hello - I'm new to the forum.  I'm working on restoring a Philco 46-1226 Code 125 Radio/Phono and console.  The Phono is beyond repairs.  I want to replace the phono with a newer cell phone wifi device to stream music into the phono input.  I read that you v=can connect the left and right wifi outputs together through 4.7K resistors.  Then go through a small coupling cap (maybe 1uF) to the top of a 100k pot.  Bottom of the pot to ground and use the wiper as the phono input.  I'm not really sure if this is the best technique. What is the typical 'maximum' signal strength of the phono input?  I'm not sure if I b=need to expect milli-volts or volts as the max input.  Any advice or suggestions would be greatly appreciated.