Philco 71 Code 125

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12, 2025) x

Linear Mode

Philco 71 Code 125

dconant
Senior Member

Posts: 555
Threads: 89
Joined: Jun 2022
City: Marion State, Province, Country: NY

1 hour ago

Really Rod? I know you would not steer me wrong but AI say this is a short circuit? What if I moved the 6 volt center tap to chassis ground. I agree the HV center tap is the B minus buss.

Reason I am questioning this is because I took the power trans out to replace the ratty wire and some how I forgot to note where the 6 volt center tap connected. Dang I hate when that happens.

Dan

And life just keeps getting more complicated.

Find

« Next Oldest | Next Newest »

Messages In This Thread

Philco 71 Code 125 - by dconant - Yesterday, 08:06 AM

RE: Philco 71 Code 125 - by dconant - 8 hours ago

RE: Philco 71 Code 125 - by RodB - 6 hours ago

RE: Philco 71 Code 125 - by dconant - 1 hour ago

RE: Philco 71 Code 125 - by RodB - Less than 1 minute ago

View a Printable Version

Users browsing this thread: 7 Guest(s)

Recent Posts
Philco 71 Code 125
This might be one of those cases where it's a ground to an AC voltage and B- to DC.RodB — 08:22 PM
Philco 71 Code 125
Really Rod? I know you would not steer me wrong but AI say this is a short circuit? What if I moved the 6 volt center ta...dconant — 06:40 PM
54C Cabinet Refinish
Roy; Personally I would have left the asbestos alone if it were my set, but you can find a modern substitute that som...Arran — 04:51 PM
Philco 71 Code 125
Looks like that might be the B- buss, so that would be correct.RodB — 01:32 PM
Philco 71 Code 125
I noticed on the code 121 schematic the center tap for the 6 volt winding and hv winding are tied together. Is this corr...dconant — 12:16 PM
Philco 45-6365 Universal IFT Instruction Manual
The Philco Parts Catalog for 1942 shows it as usable for 175 kHz, 260 kHz, and 465 kHz. The instructions will show how t...DaleHCook — 11:19 AM
Stromberg Carlson 1500 Squeal
Hello Rob, I agree with you—I have one here at my house that I need to check out. It’s way over-engineered just to make...radiorich — 11:05 AM
My Atwater Kent 84
Well getting around to restoring my AK84. Mike was a big part in me being able to snatch this one a few years ago. I won...462ron — 10:57 AM
Plug Voltages Needed For A 1943 CRV-20130 Power Supply
The engine is a B&S 23 inch cast Iron holds 2 quarts of oil. The Generator is a 4 pole 1800 rpm mine was made in 195...David — 10:51 AM
Philco 45-6365 Universal IFT Instruction Manual
Dale: Modified topic as suggested. It is not for a specific project. I found it in a box of stuff I recently purchased...GRG — 10:34 AM

Who's Online

There are currently 1490 online users. [Complete List]
» 1 Member(s) | 1489 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me