[MrFixr55]

Technically, that's C-. B- is chassis ground. The resistor between chassis ground and the HV center tap makes the HV center tap the most negative point in the set. You would note that grid bias resistor to the output stage ties to this point. other grid bias resistors tie to resistor taps between this point and chassis ground. On many (or most) pre WWII radios, this scheme was used to generate bias voltages for various tubes, especially the Output stage but the 1st AF stage also.

It is legit to tie the heater center tap to this point as long as no other point in the heater circuit is tied to chassis ground. There was a theory that the heater be kept negative with respect to the cathode. Can't remember the reason why, but this practice was eventually abandoned when center taps were abandoned. Back in the day of directly heated tubes like 71s, 45s, 47s, 2A3s, etc., the center tap was important to reduce the hum levels when these filamentary cathodes were powered by AC. The center tap of the heater winding was where the cathode bias resistor was connected to in some late 1920s - early 1930s sets. In other sets, the center tap was to chassis ground and the grid bias resistor, or interstage transformer center tap connected to the HV secondary center tap.

BTW, AI is about as correct as the internet is. It is also the Wild West. AI is only as good as its source material.

Hope this helps