GE F-135

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

GE F-135

Howard2
Junior Member

Posts: 8
Threads: 4
Joined: Aug 2010

10-05-2011, 11:08 AM

Thanks for your response. The motor runs both ways and worked fine for 2 days and then one of the windings opened. Resistance measurements show open in one set of windings and 1 or 2 ohms through the other winding. The tuning worked great for a short time. The motor cap was way off in value and it ran slowly until the correct value was installed. Running it with the wrong value may have caused over current condition. Thanks. Howard2

Find

« Next Oldest | Next Newest »

Messages In This Thread

GE F-135 - by Howard2 - 10-03-2011, 09:04 AM

Re: GE F-135 - by Arran - 10-05-2011, 01:54 AM

Re: GE F-135 - by Howard2 - 10-05-2011, 11:08 AM

Re: GE F-135 - by Arran - 10-05-2011, 09:57 PM

Re: GE F-135 - by Howard2 - 10-07-2011, 11:11 AM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

Who's Online

There are currently 4760 online users. [Complete List]
» 1 Member(s) | 4759 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me